User manual HUSQVARNA TS 400 F

[. . . ] PREFACE TO THE MANUAL Before leaving our factory every machine passes an exacting inspection programme in which everything is checked minutely. Following the instructions will ensure that your machine gives long service, in normal operating conditions. The user advice and spare parts mentioned in this document are given as an indication, and do not constitute an undertaking. No warrantee will be granted in the event of errors or omissions, or for damage occurring during delivery, or caused by the design or use of the machine. [. . . ] That the warnings and instructions marked on the machine are followed (adequate personal protection, correct use, general safety instructions, etc). That no modification, transformation or addition is detrimental to safety and that it is carried out without prior authorization from the manufacturer. That only genuine spare parts are used for repairs. Any application not corresponding with the intended use (use of a saw blade, abrasive disc, etc) is prohibited. Use : Sawing marble, stone, granite, brick, cement and all facings (porcelain, glazed tiles, ceramics, etc). check the supply cable lead periodically. 1 PLACING ON FEET (SEE FIG 8) 1 Chassis-tank 2 Leg 3 Head clamping handle 4 Water pump 5 Handwheel height locking 6 Adjustment crank 7 Loading wheelst 8 Drain plug 9 Motor 10 Lack of voltage switch 11 Hood 12 Disc casing 13 Housing cover 14 Movable table 15 Table stop 16 Movable table stop 17 Manufacturer's plate 18 Cutting guide 19 Table locking 20 Carrying handles 21 Transport wheels 22 Settling tank 23 Water level 4 Handling - transport Inspection before starting Please read the instructions for use prior to operating the machine for the first time. The use of ear protection is mandatory. The working area must be completely cleared, well lit and all safety hazards removed (no water or dangerous objects in the vicinity). Any persons not involved in the work should leave the working area. Use blades suitable for the work to be done (speed, geometry, application, etc. Dismantle your machine into three parts. The operator must wear protective clothing appropriate to the work he is doing. We recommend that this includes both eye and ear protection. - Use the following types of plug, single phase 2 P + E, or 3xPx+xE / 3xPx+xNx+xE according to the corresponding voltage. - Extension lead: Cable size sufficient for the electrical power, connection to the mains by a H07 RNF type cable of the following size: - 3 x 2. If the machine is fitted with a brake motor, do not use the quick-tightening nut. Take care about the direction of rotation which is shown by an arrow on one of the faces. Make sure the contact faces of flanges, of blade and the axle are clean. Starting up Always pay extreme care and attention to the preparation of the machine before starting up Remove all adjustment tools and wrenches from floor and machine Always keep blade guard in place Electrical connection - ELECTRICAL SAFETY : Operate this machine only on a supply equipped with a 30 mA earthed current-limiting circuit-breaker. Otherwise, consult our catalogue for appropriate models. - The RCCB must be used correctly, including testing it regularly. [. . . ] In the event of a long period of use pay special attention to the maintenance and protection of the disc. Make sure that sufficient water is sprayed onto the disc. Make sure that the contact faces of the disc, the flanges and the spindle are clean. The manufacturer declines all responsibility for loss or damage resulting from misuse or any modification, alteration or powering that does not conform to the manufacturer's original specifications. [. . . ]