User manual HUSQVARNA TS 73 R

[. . . ] Before leaving our factory every machine passes an exacting inspection programme in which everything is checked minutely. Following the instructions will ensure that your machine gives long service, in normal operating conditions. The user advice and spare parts mentioned in this document are given as an indication, and do not constitute an undertaking. [. . . ] We recommend that this includes both eye and ear protection The use of ear protection is mandatory. Any persons not involved in the work should leave the working area Use only blades marked with a maximum operating speed greater than blade shaft speed Release the two knobs (C) - [SEE FIG. 4], remove them and then remove the guard. Take care about the direction of rotation which is shown by an arrow on one of the faces. Make sure the contact faces of flanges, of blade and the axle are clean. Lock the head on the rear part of the machine using clip (A) - [SEE FIG. 2] · Loosen the two flywheels (B) of the front legs, swivel them, then retighten the flywheels (B) [SEE FIG. Repeat the same procedure for the back legs. To reinstall the machine on its legs, carry out the same procedure in reverse. For these different operations always disconnect the machine - ELECTRICAL SAFETY : Operate this machine only on a supply equipped with a 30 mA earthed current-limiting circuitbreaker. Otherwise, consult our catalogue for appropriate models. - The RCCB must be used correctly, including testing it regularly. For tools supplied with an integral RCCB in the cable or in the mains plug, if the cable or plug has been damaged, repairs must be carried out by the manufacturer, one of his agents or by a qualified repair workshop to avoid any risks resulting from errors. Get into a comfortable, balanced position. Always keep blade guard in place · As each saw is fitted with a selfpriming pump, the disk is sprayed as soon as the saw is turned on. Engines : * Standard : with on-off switch with no-volt release switch - 1-phase, 230 V, 1000 W (1, 3 hp) 3 x 1. 5 mm2 with plug (cable 2 P + E) * Optional : with cut-out switch with or without ammeter - 1-phase, 110 V, 1000 W (1, 3 hp) 3 x 2. - Make sure that the mains voltage corresponds with that marked on the manufacturer's plate on the machine. [. . . ] The manufacturer declines all responsibility for loss or damage resulting from misuse or any modification, alteration or powering that does not conform to the manufacturer's original specifications. The noise level of this machine is measured according to the S 31. At the work station, the sound pressure level may exceed 85 db (A) In this case individual protection measures must be taken. [. . . ]