User manual HUSQVARNA WB48 S

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Switch off the engine by releasing the engine brake handle before carrying out any checks or maintenance. [. . . ] Never run with the machine when it is running. You should always walk with the lawn mower. Shut down the engine before changing the cutting height. the cutting height adjustment is spring assisted. The cutting height can be adjusted in 6 different steps. When the grip on the engine brake handle is released the engine should stop. Check the engine brake as follows: Do not set the cutting height too low as there is a risk that the cutters might hit slopes with unevenness. ⷠTo raise the cutting height move the lever to the left and then forward. apply full throttle and then release the brake handle. The engine should stop and the drive should disengage. To lower the cutting height move the lever to the left and then backward. The engine brake should always be adjusted so that the engine stops within 3 seconds. Your machine is equipped with a vibration damping system that is designed to minimize vibration and make operation easier. This section describes the machines safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. " section to locate where this equipment is positioned on your machine. Never use a machine with faulty safety equipment. The machine's safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your service agent to get it repaired. The handlebar system's steel tube and the cutting cover are designed to minimise the vibrations from the engine. The machines vibration damping system reduces the transfer of vibration between the engine unit/cutting equipment and the machines handle unit. WB48S e och WB53S e This model also has 4 vibration dampers fitted on the handlebar unit to further reduce vibrations. Overexposure to vibration can lead to circulatory damage or nerve damage in people who have impaired circulation. [. . . ] Check that the engine brake works correctly and is undamaged. Check the airfilter and clean it when it´s necessary. If the engine does not start after taking these actions, contact the nearest authorised service agent. If the cutting result is not satisfactory and the grass straws are fuzzy on the cut face, replace the cutter. [. . . ]