User manual HUSQVARNA WE261

[. . . ] Operator’s Manual 26" RIDING MOWER SIDE DISCHARGE ELECTRIC START Catalog No. WE261 IMPORTANT: Read and follow all Safety Rules and Instructions before operating this equipment. Patents Pending 532 43 32-03 Rev. 10 TABLE OF CONTENTS Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Rules. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Product Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 1. Check engine oil with riding mower on level ground. 2. Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL mark on dipstick is reached. Do ” not overfill. When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. 1. Be sure freewheel control is in the transmission engaged position. 2. Sit on seat in operating position, depress clutch/brake pedal and set parking brake. 3. Place motion control lever in neutral (N) position. 4. Move deck clutch to disengaged position. 5. Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. NOTE: If at high altitude (above 3000 feet) or in cold temperature (below 32°F) the fuel mixture may need to be adjusted for best performance. 14 RECOIL STARTING SYSTEM This unit is equipped with an engine recoil starting system. If the battery is too weak to start engine. 3. Make sure unit is in neutral position. 5. Pull recoil cord to start engine. Gasoline Filler Cap • Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. • Regulate ground speed by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired. • When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used. Recoil Starter Handle MOWING TIPS • Mower should be properly leveled for best mowing performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trimming. • Drive so that clippings are discharged onto the area that has already been cut. Have the cut area to the right of the riding mower. This will result in a more even distribution of clippings and more uniform cutting. • When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. [. . . ] COTTER BRACKET, BRAKE SUPPORT COVER PEDAL COVER, BRAKE PEDAL SCREW, 1/4-20 X 3/8 BRAKE CABLE MOUNT BOLT, 5/16-18 X 3/4 CAP HUB AXLE E RING #5133-62 SPROCKET II TOOTH SPLINED NOTE: All component dimensions given in U. S. inches 1 inch = 25. 4 mm 33 STEERING RIDING MOWER - -CATALOG NO. WE261 27 25 24 26 23 22 28 21 18 19 17 13 16 4 15 19 8 9 12 8 9 2 6 14 10 20 11 9 8 7 2 7 30 2 3 6 4 1 5 29 4 LRV-Steering_1_r2 1 3 2 30 34 STEERING RIDING MOWER - -CATALOG NO. WE261 KEY PART NO. NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 532 43 65-00 812 00 00-01 532 18 89-67 532 12 17-49 532 42 80-34 532 12 49-31 532 12 49-37 532 42 10-76 819 13 14-14 532 42 80-57 532 42 80-35 532 42 80-36 874 78 05-24 819 13 10-16 873 80 05-00 532 42 80-44 532 42 82-52 532 19 52-27 817 00 05-12 532 42 80-45 532 42 83-47 532 42 82-13 532 18 67-37 819 18 38-12 873 94 08-00 532 43 65-01 532 43 65-02 532 19 98-49 532 42 80-33 532 43 64-99 DESCRIPTION WHEEL ASM (FRONT) E-CLIP WASHER, HARDENED WASHER, 1/4 X 3/4 SPINDLE, RH WASHER, HARDENED THRUST BUSHING, STEERING COLUMN PIN, 5/64 X 3/4 COTTER WASHER WELDMENT, LWR STRG SHAFT LINK, STRNG LH LINK, STRNG RH BOLT, 5/16-18 X 1 1/2 WASHER NUT, 5/16-18 BUSHING, STEERING SNAP SUPPORT, UPPER STEERING BUSHING, UPPER STEERING BOLT, 5/16-18 X 3/4 CLIP RETAINER SPRING , COVER, STEERING COLUMN SHAFT, STEERING ADAPTER, STEERING WHEEL WASHER, 9/16 X 2 3/8 12 GA. [. . . ]