User manual HUSQVARNA WG 4815 P

[. . . ] Operator's manual WG4815P/968999278 WG3613P/968999116 WG3213P/968999114 Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English OPERATOR’S MANUAL MOWER WG3213P WG3613P WG4815P Contents Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Congratulations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not spray high pressure spray directly on top of spindles. Avoid getting engine too wet. • • WARNING!Never drive the machine on terrain that slopes more than 10°. Mow slopes up and down, never side-to-side. Avoid sudden directional changes. 8011-514 Clean mower deck after each use English-28 OPERATION Stopping Emergency stop Release both hands from the operator presence lever handles. When both operator presence levers return to their outer position, the engine will quit and the mower will stop. or Pull both motion control levers firmly against handle grips and hold them securely in place. Use thumb latches to lock both motion control levers in neutral positions. Then stop engine by pulling throttle control back and shut off the key switch. Normal operating stop 1. Pull both motion control levers firmly toward the handle grips to stop forward motion. Use thumbs to lift thumb latches into the neutral slots. Move the throttle control to the slow position. Move blade engagement control to the off position. Move shift lever to the neutral position. Stop engine, refer to “Stopping the Engine” on page 30. 2. 6. IMPORTANT INFORMATION Close fuel valve at the end of each mowing job. Braking Squeeze both motion control levers towards the handle grips. If desired secure them using the thumb latches for parking brake. English- 29 OPERATION Stopping the Engine Allow the engine to idle a minute in order to attain normal operating temperature before stopping it, if it has been worked hard. Avoid idling the engine for longer periods, as there is a risk of the spark plugs fouling. 1. When the machine is standing still, activate the parking brake by moving the thumb latches to the park brake position. 8011-659 Parking brake 2. Disengage the blades by the blade engagement lever. 8011-694 Disengage the blades 3. Move the throttle to the idle position (tortoise symbol). Turn the ignition key to the stop position. Remove the ignition key. 4. 8011-709 Throttle 5. Shut OFF the fuel valve. IMPORTANT INFORMATION Close fuel valve at the end of each mowing job. 8011-437 Fuel valve, closed English-30 OPERATION Adjustment of cutting height The cutting height can be adjusted by three methods: • Moving spacers between the upper side and the lower side of the caster swivel according to "Cutting height table". Moving spacers between the upper side and the lower side of the blades according to "Cutting height table". For removing and installation of blades, refer to “Blade replacement” on page 46. [. . . ] Change engine oil. English- 65 SERVICE JOURNAL Action Date, mtr reading, stamp, sign 25-Hour Service 1. Check the fuel pump’s air filter (Kawasaki engine). Check the tire pressures and tire damage. Check/clean the engine’s cooling air intake. [. . . ]