User manual HUSQVARNA WHF5223

[. . . ] Operator's Manual Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. WHF5223 / 966947006 WHF6123 / 966947007 English In order to implement improvements, specifications and designs can be altered without prior notification. Note that no legal demands can be placed based on the information contained in these instructions. The use of other parts voids the warranty. Do not modify or install non-standard equipment to the unit without consent from the manufacturer. [. . . ] Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur. Fuel cap 8062-003 WARNING!The engine and the exhaust system, become very hot during operation. Allow engine and exhaust system to cool at least two (2) minutes before refueling Husqvarna-19 operation Before Starting • Read the sections on Safety and Controls before starting the machine. • Perform the daily maintenance before starting (see Maintenance Schedule). • Check that there is sufficient fuel in the fuel tank. The following conditions must be fulfilled before the engine can be started: • The control for engaging the blades must be in disengaged (down) position. • The speed control lever must be in the start position. Be thoroughly familiar with control operation and function before using the mower. Starting position 8062-010 • The neutral locks for the drive levers should be in locked position. Do not operate the mower if the interlock safety system allows operation or starting in any unsafe condition. Neutral lock 8062-003 20 - Husqvarna operation Starting Engine Open fuel shut-off valve. Fuel shut off valve - open 8062-007 Set throttle control at the lowest position and engage the choke (if needed). Do not use choke when the engine is warm. Set throttle control 8062-010 WARNING!Do not run the engine indoors, in enclosed or poorly ventilated spaces. Engine exhaust fumes contain poisonous carbon monoxide. Confirm that the speed control lever is in the start position. IMPORTANT INFORMATION Do not let the recoil cord snap back by itself. This may damage the cord or the recoil starter assembly. Speed control in the start position 8062-009 Husqvarna-21 operation Turn ignition key to ON position. Ignition key 8062-003 Release the parking brake by pivoting the pedal back and downwards until it clears the brake shaft. Parking brake 8062-005 22 - Husqvarna operation Running Depress one operator presence lever and move the speed control to the desired speed. Pull the blade engagement control upwards. The best cutting and bagging is obtained with engine at top rpm. While on level terrain, squeeze both drive levers slightly. Using thumbs, slide each neutral lock out the locked position. Slowly release both drive levers at the same time to begin forward motion. [. . . ] 6. Lubricate all grease zerks, joints, and axles. 7. Store the machine in a clean, dry place and cover it for extra protection. WARNING!Never store an engine with fuel in the tank indoors or in poorly ventilated spaces where fuel vapor can come in contact with open flames, sparks, or a pilot light such as in a boiler, hot water tank, clothes drier, etc. It is very flammable and can cause serious personal injury and property damage. [. . . ]