User manual HUSQVARNA WS 462

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Approved protective helmet Approved hearing protection Protective goggles or a visor Breathing mask Protective goggles or a visor must be worn. [. . . ] When making the last cut, the saw should be mounted on an adjacent fixed wall. As the rail is symmetrical, the saw unit can be turned to make a new cut on the other side of the rail. In this way a cut piece is obtained that is in an easily handled size, making it easier to remove from the workplace. Since the blade rotation direction can be selected, the water spray from the blade can also be selected regardless of how the saw is turned on the rail. This is done by feeding the blade 3-7 cm (1, 2"-2, 8"). The cut should not be made at maximum speed, but with care in order to obtain a straight cut and with that a basis for the next cut. the cutting arm allows blades up to 1 000 mm (40") to be used as the start blade. It is, however, recommended to start cutting with an 800 mm (31. When the pilot cut is finished, a deeper cut can be made. The depth of these is determined from instance to instance and depends on factors such as hardness of the concrete, existence of reinforcing bar, etc. If you change blades to cut deeper in the same cut, make sure the thickness of the blade matches the width of the groove. The heavy weight of cut material can cause extensive damage if it is not moved under controlled conditions. Never use a blade for any other materials than that it was intended for. Operating saw blades at rotational speeds greater than those recommended by the manufacturer can cause blade damage and possibly subsequent injury. To utilises the input effect in the best possible way the saw is mounted on Husqvarna' the latest rail. This is a very stable rail, which allows the saw to be controlled more precisely, which in turn results in more efficient cutting. As the equipment's component parts work with small losses and as the blade is moved in 50 mm closer to the rail compared to earlier models, which has also resulted in a saw with an extremely compact design and at the same time as efficiency has increased. 2 m One track 2 m Four wall mountings One track holder One connector One blade guard 800 or one blade guard 1000 One blade guard guide One tool kit One bottle of Husqvarna oil 150 It is our wish that you will be satisfied with your product and that it will be your companion for a long time. Think of this operators manual as a valuable document. By following its content (using, service, maintenance etc) the life span and the second-hand value of the machine can be extended. If you will sell this machine, make sure that the buyer will get the operators manual. A purchase of one of our products gives you access to professional help with repairs and services. [. . . ] In order for the blade spindle to be fitted as easily as possible, it may be necessary to grease the hexagonal blade spindle. All types of repairs may only be carried out by authorised repairmen. This is so that the operators are not exposed to great risks. After 100 hours of operation, the message "Time for servicing" is displayed. [. . . ]