User manual HUSQVARNA Z 4818

[. . . ] Operators Manual Models: 968999250 / Z4818BIA Please read these instructions carefully and make sure you understand them before using the machine. MANUAL NO. IR (09/18/04) Congratulations on the purchase of your Husqvarna mower. It has been designed, engineered and manufactured to give you the best possiblbe dependability and performance. This manual has been prepared for the owners and operators of the models called out on the front cover of this manual. [. . . ] Make all turns slowly. 22 OPERATION TO TRANSPORT (See Fig. 7) When pushing or pulling the mower, be sure to engage the IZT (Integraded Zeroturn Transaxle) bypass linkages. The IZT bypass linkages are located on the rear of the frame, below the rear engine guard. 1 CAUTION Do not tow this vehicle, it may cause damage to the drive system. IZT BYPASS LINKAGE CZ-10 • • • Raise the deck into the highest cutting position. Pull the IZT bypass linkages out and into the slots and release so that it is held in the bypass position. To reengage the IZT’s to drive, reverse the above procedure. FIGURE 7A 1 2 CZ-11 WARNING Do not tow any trailers, etc. They may jackknife or overturn causing damage to the mower and possibly serious injury to the operator. 1. IZT BYPASS LINKAGE IN DRIVE POSITION 1 2 CZ-12 FIGURE 7B 1. IZT BYPASS LINKAGE IN BYPASS POSITION 23 OPERATION BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL • • • • The engine in your mower has been shipped from the factory, already filled with 10W-30 motor oil. Check engine oil with the mower on level ground. Refer to you Engine Owners Manual for correct oil level. To change engine oil, see the Customer Responsibilities section of this manual. ADD GASOLINE • Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Purchase fuel in quantities that can be used within 30 days to ensure fuel freshness. IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32° F. (0° C. ), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING. CAUTION Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it the run until the fuel lines and carburetor are empty. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur. WARNING Fill to bottom of filler neck. [. . . ] Check/replace solenoid or starter. Engine clicks but will not start Loss of power 10. Engine valves out of adjustment. Set in "Higher Cut" position/reduce speed. Drain fuel tank and refill with fresh gasoline. Drain fuel tank and carburetor, refill tank with fresh gasoline and replace fuel filter. [. . . ]