User manual HUSTLER 351254

[. . . ] Super Z Diesel Owner's Manual ······· Hustler Turf Equipment ····· P. O. Box 7000 ··· Hesston, Kansas · 67062-2097 351254_041505 WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. 351254_041505 TABLE OF CONTENTS 1. General Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sect. Safety Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sect. [. . . ] Four deck lift pivots, located to the side of the operator's footrest 3. Blade spindle assemblies The spindle assemblies require lubrication annually. Each spindle shaft is equipped with a grease zerk located under the deck. Use no more than one or two ounces of SAE multipurpose grease, (1 to 2 pumps on an average grease gun). Do not force lubricant in to grease zerks. Bearings are sealed and do not require much lubricant. Wheel (lug) nuts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65-75 . . . . . . 88. 14-101. 7 Wheel motor nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . 350-375 . . . . . 474. 6-508. 5 Blade spindle bolt top . . . . . . . . . . . . . . . . . . . . . . . . 65-75 . . . . . . 88. 14-101. 7 Blade spindle bolt bottom . . . . . . . . . . . . . . . . . . . . . 118 . . . . . . . . . . . . . . . . 160. 0 It is recommended that these be checked after the first 2 hours of operation, initially and every 50 hours following removal for repair or replacement. For all other torques refer to the tractor parts manual for standard torque chart. For engine torque values, see engine owner's manual. Tires It is important for level mowing that the tires have the same amount of air pressure. The recommended pressure are: Drive wheels. . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-10psi (55-69 KPa) Gauge wheels. . . . . . . . . . . . . . . . . . . . . . . . . . 8-10 psi (55-69 KPa) Solid fill tires are not recommended for Hustler turf equipment. On any machine, with solid filled tires, the warranty claim will be denied. WARNING: Explosive separation of a tire and rim can cause serious injury or death. Do not attempt to mount a tire without the proper equipment and experience to perform the task. Always maintain the correct tire pressure and never over inflate. Never weld or heat a wheel and tire assembly as an explosion may occur. When inflating tires stand to one side and not in front of or over the tire assembly. Check tires for low pressure, blemishes, damaged rims or missing lug bolts and nuts. Electrical system The electrical system is a 12 volt, negative ground. Recommended battery size is a garden tractor BCI group U1R with 225 or better cranking AMP rating. Two maintenance-free batteries are recommended. Otherwise, follow battery manufacturer's maintenance, safety, storing and charging specifications. The batteries are located under the seat. 4-3 WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to cause cancer and reproductive harm. WARNING: Avoid skin contact with battery acid. [. . . ] Drive motors mounted to . 179 IN (. 45 CM) welded steel. Front caster wheels mounted with ball bearings on each wheel. Front caster forks are . 50 IN (1. 27 CM) steel DECK LIFT: Foot-operated deck height adjustment. Detent for setting height, transport position. [. . . ]