User manual HYUNDAI HL730-7A BROCHURE

[. . . ] (Option) 3 Full automatic shift lever A single lever on the left side of the steering column gives the operator fast and easy control of speed and direction. Push the lever forward to drive forward, pull it back for reverse. Travelling is automatically changed from 1st stage to given stage according to travel speed and traction effort. The operator can select two kinds of automatic modes (1st<->4th, 2nd<->4th). [. . . ] The large access engine-side-panels permit easy and safe inspections. The fuel and oil filters can be spun on and off for quick replacements. Up-to-date hydraulic remote cooling fan Minimum fuel consumption and low noise is realized by using a hydraulic cooling fan sensing coolant temperature, intake air temperature, transmission oil temperature and hydraulic oil temperature. Reversible cooling fan is installed. 9 Specification Engine Maker/Model Type CUMMINS QSB4. 5 4-cycle, turbocharged, charge air-cooled direct injection, electronic controlled diesel engine Bore x Stroke Displacement Compression ratio Air cleaner Gross power Net power Maximum torque No. of cylinders 93 kW (125 HP) at 2, 100 rpm 89 kW (119 HP) at 2, 100 rpm 560 Nm (408 lbf. ft) at 1, 400 rpm 4 Alternator Battery Starting motor Cooling 107 mm (4. 2") x 124 mm (4. 9") 4. 5 litres (275 cu in) 17. 2 : 1 Dry, dual elements 24V, 70 Amp 2 x 12V, 80 Ah. 24V, 3. 7 kW Hydraulic remote cooling system Net power output of standard engine as installed in this vehicle (per SAE J1349) complete with fan, air cleaner, alternator, water pump, lubricating oil pump and fuel pump. No derating for continuous operating required up to 3, 048 m (10, 000 ft). This engine meets the EPA(Tier III) / EU(Stage III-A) Emission regulation. Transmission Torque converter type Stall torque ratio 3-elements, single-stage single-phase 2. 382 :1 Travel speed Forward km/h (mph) 6. 2 (3. 9) 11. 4 (7. 1) 22. 1 (13. 7) 36. 0 (22. 4) Reverse 6. 5 (4. 0) 12. 0 (7. 5) 23. 1 (14. 4) Full automatic power shift, countershaft type with soft-shift in range and direction. Properly matched torque converter to engine and transmission for excellent working ability. Axles Drive system Mount Four-wheel drive system Rigid front axle and oscillating rear axle +/- 12° (total 24°) Hub reduction Differential Planetary reduction at wheel end Torque proportional differential Rear axle oscillation Reduction ratio 21. 462 Hydraulic System Type Open-centred, tandem circuit system. Helical gear type, 140 litres/min (37. 0 gal/min)@governed rpm Two function valve with single or two lever controls: Optional third-function valve with auxiliary lever. Bucket Controls Type Pilot operated lift and tilt circuit, singlelever (joystick) control standard. The valve has four functions: raise, hold, lower and float. An adjustment for automatic kick-out from horizontal to full lift is installed. The valve has three functions: tilt back, hold and dump. An adjustment for automatic bucket position to the desired load angle is installed. of cylinders-bore x stroke; Lift 2-105 mm (4. 1") x 772 mm (30. 4") Tilt 1-120 mm (4. 7") x 510 mm (20. 1") 2-95 mm (3. 7") x 775 mm (30. 5") HL730-7A / HL730XTD-7A Raise (with load) Dump Lower (empty) Total sec 10 Lift Circuit Pump Control Valve Tilt Circuit Relief Valve Setting Pilot System Type 20, 5 MPa (2, 990 psi) Pilot oil pressure is generated by the pilot oil supply unit. Cylinder HL730-7A HL730TM-7A Cycle Time Relief Valve Setting 2, 9 MPa (427 psi) HL730TM-7A 5. 6 sec 1. 4 sec 2. 8 sec 9. 8 sec 5. 6 sec 1. 0 sec 2. 8 sec 9. 4 sec Specification Brakes Service Brakes Hydraulically actuated, wet disc brakes actuate all 4 wheels independent axleby-axle system. Single pedal braking including clutch cut off switch. Type Pump Steering System Full hydraulic power steering Helical gear type, 74 litres/min (20 gal/min) 20, 5 MPa (2, 990 psi) Double acting 60 mm (2. 4") x 390 mm (15. 4") 40° (each direction) Relief Valve Setting Parking Brake Spring-applied, hydraulically released wet disc brake in front axle. When brake oil pressure drops, indicator light alerts operator and parking brake automatically applies. Cylinder Type Bore x Stroke Steering Angle Emergency Brake Features - Centre-point frame articulation. - Load-sensing, pressure-compensated system. - Steering-wheel operated metering pump controls flow to steering cylinders. [. . . ] Low Emission Diesel, Tier-ll Optional Equipment 24-volt to 12-volt DC converter Air condition : . heater Beacon light, rotating Cutting edge, bolt-on type Differential, Front : no spin, Rear : limited slip Fire extinguisher High lift arrangement with optional counterweight, 410kg (904 lb) Hourmeter Hydraulic control, 2 lever Hydraulic control, 3 lever Hydraulic arrangement, 3-valve Lighting, auxiliary, 4 on roof Mud guard Open Canopy (ROPS/FOPS) Operator suit Ride control system . 3" static seat belt & adjustable mechanical suspension . 3" retractable seat belt & adjustable air suspension Tool kit Tooth, 1 piece, bolt-on type Guards . [. . . ]