User manual HYUNDAI HYM43SP

[. . . ] The operator of the machine is responsible for, and has a duty of care in making sure that the machine is operated safely and in accordance with the instructions in this user manual. Keep the manual safe and pass it on if the machine is loaned or sold to another user. Please note the following safety points. The machine should never be left it in a condition which would allow an untrained or unauthorised person/s to operate this machine. [. . . ] You must only use straight, fresh unleaded petrol ­ DO NOT mix petrol with oil. You must clean up any spilt fuel before starting the engine. Before use you MUST check and if necessary adjust the OPC control cable, if it is too loose the the lawnmower will not start. To locate the adjuster follow the cable from the OPC handle to the engine body where you will see the OPC adjuster. If the OPC cable is too loose you will need to tighten it. Start by undoing the lock nut (anticlockwise) then turn the adjuster nut in a clockwise direction. Attempt a start if adjusted correctly the lawnmower will start once started you must tighten the locknut, continue to adjust until lawnmower starts. Some models have a cover over the adjuster remove to adjust and replace once task is completed. Mulching plug HYM46SP only ­ In mulching mode you must remove the grass catcher. Lift the rear cover and remove the grass catcher. Push the mulching plug (wedge) into the discharge channel and lock it into the slot. Cut & Drop/Side discharge HYM46SP only - In Cut & Drop/Side discharge mode you must remove the grass catcher. For grass collection mode you must remove the mulching plug and side discharge chute. Push the throttle lever all the way forward. Make sure the blade is free of long grass and the cutting height set to maximum. Pull back the Operator Presence Control (OPC) lever towards the main handle. Pull the recoil starter handle swiftly ­ repeat until engine starts. Before stopping the machine allow the engine to cool down for a few minutes. You MUST allow the blades to come to a full stop before carrying out any maintenance on the machine. To STOP the machine release the Operator Presence Control (OPC) lever and allow it to move away from the main handle. Always use the lawnmower with the grass catcher, or rear deflector in position. Stop the engine before emptying the grass catcher or before you change the cutting height. [. . . ] Remove any debris from slots in shroud, blower housing, air passages. DO NOT use machine until vibration issue has been fixed Too much free play in cable. Make sure handle is correctly located into the Contact your dealer or after sales on 01646 All machines are pre delivery inspected so there may be residual oil left in the Genpower Ltd confirms that these Hyundai products conform to the following CE Directives; 2006/42/EC Machinery Directive 2004/108/EC EMC Directive 2000/14/EC, Amended by 2005/88/EC Noise Emissions Directive 97/68/EC_2010/26/EC NRMM Emissions Directive We do not offer a takeback scheme for the recovery of Waste Electrical Electronic Equipment (WEEE) & Batteries instead the responsibility to dispose of WEEE and or Batteries is passed onto you by us. So when it becomes necessary to dispose of your machine you must take it to your local Civic . [. . . ]