User manual HYUNDAI LM3601E

[. . . ] EN NOTE The figures and illustrations in this manual are provided for reference only and may differ from your specific model. Before using this lawn mower, Carefully and become familiar with all By electrical shock, burning and flying Well as objects and persons in the Manufacturer does not assume any liability Keep these operation instructions readily accessible for later use. If you pass this lawn mower on to other persons, also pass on the operation instructions. Before using the lawn mower, read these operation instructions carefully and become familiar with all operating elements and functions. [. . . ] For this purpose, it should be rotated until it clicks. D2: Screw on the lower handlebar by turning the corresponding eccentric clamps. In the open state the eccentric clamps should be aligned as shown in the image. D3: Snap shut the eccentric clamps on both sides. Select the hole that corresponds to your desired height of the handlebar. D6: Fix the power cable to the handlebar with the cable clips. Make sure that the cable stays away from moving components and has enough space. D7: Lift the impact protection and hang up the grass basket. The device must not be used without the grass basket. operation (Image E) E1: Plug the power plug into the socket. Pay strict attention to the safety instructions in this manual. To obtain a strain relief of the cable, fix the power cable as shown in the image. E2: To start the device, hold down the safety button and pull the engine lever. After starting the device, you can release the safety button. The engine lever, the blade keeps moving for a few seconds. Be sure to wait until the engine and the blade have come to a complete standstill before transporting the device or performing any work on the device. E4: The device is equipped with a central 5-step height adjustment which allows you to adjust the lawn height between 20 and 70 mm. E5: To adjust the height, pull the handle of the height adjustment slightly to the side and move it to the desired position. The height adjustment may only be carried out with a completely switched off device! e6: The lawn mower has a fill level indicator. If the grass catcher is not full, the flap of the indicator stays open and air comes out. E7: If the grass catcher is full, the air flow is disrupted and the flap closes. [. . . ] This could possibly lead to injuries or damage. To clean the grass catcher, detach it from the lawn mower, wash it with water and let it dry. Make sure that the grass catcher is completely dry before using it again. blade Maintenance (Image G) Before the blade maintenance, the device should be disconnected from the mains and cleaned. [. . . ]