User manual I-GO EVERYWHERE MAX

[. . . ] Do not attempt to disassemble the adapter. It has no serviceable or replaceable parts inside. Voltage in the adapter can cause injury. If the adapter malfunctions, immediately discontinue use and contact iGo Technical Support. [. . . ] You can receive help in a variety of ways: Sales/Customer Service: 1-888-205-0093 Technical Support: 1-800-474-7593 Web: www. iGo. com FCC Compliance for iGo dualpower® Accessory This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ©2002-2007 Mobility Electronics, Inc. Mobility Electronics, iGo and iGo dualpower are registered trademarks and powered up and connected is a trademark of Mobility Electronics, Inc. All other brand names and logos are trademarks or registered trademarks of their respective owners. Specifications are subject to change without notice. Protected by one or more of the following patents: 5, 347, 211, 6, 064, 177, 6, 700, 808, 6, 643, 158, 6, 650, 560, 6, 751, 109, 6, 775, 163, 6, 791, 853, 6, 920, 056, 6, 937, 490 and 6, 976, 885. Other United States and foreign patents pending. A Specifications AC input: DC input: Unit dimensions: Troubleshooting Device is not charging when iGo dualpower is configured Notebook not listed on enclosed compatibility chart LED does not Light burned out light but unit appears to power devices LED does not light Notebook is not charging Notebook is not charging Issue This equipment has been designed for connection to TN and IT power systems. Tip was removed without unplugging adapter Tip not installed on Notebook Input Cord Probable Cause(s) No input or output power No electricity to adapter Compatibility is always changing 100-240 VAC; 50/60 Hz 12-16 VDC; 11A Max 2. 0 x 5. 0 x 1. 24" (50. 7 x 126. 9 x 31. 0mm) See www. iGo. com for current compatibility information Contact iGo customer service (see contact information on the back of this guide) · Check plug connector · Check cable connections · Check outlet circuit breaker Unplug from outlet, wait 30 seconds and plug unit back into outlet Install tip on Notebook Input Cord See above solutions Possible Solution(s) Safety Features Surge protection Over-voltage protection Over-current limit Over-temperature protection Short circuit protection Standard Wall Outlet: As in your car, once connected, your battery will automatically charge regardless of whether your electronic device is turned on or off. Note: We recommend that you use iGo power adapters only with device batteries that meet or exceed the original manufacturer's specifications. CAUTION: Like the power adapter that came with your electronic device, this iGo adapter may get warm to the touch during use. Avoid placing your iGo adapter in direct sunlight or next to heat sensitive materials. Auto, Boat or RV: Your vehicle may need to be running in order to get power. If after checking the connections the LED is still not illuminated, you may need to check the vehicle's cigarette lighter fuse. Please refer to your vehicle manual for instructions on how to check the fuse box. Ultimately, you may need to replace the cigarette lighter's fuse. Note: In some vehicles, power to the cigarette lighter is always on. These vehicles may not require the ignition to be turned on. CAUTION: It is not recommended to have this iGo adapter connected to your electronic device when starting the engine. The power may be interrupted causing your system to reset. How to Use This iGo Combination Power Adapter Air: You will need to find the in-flight power outlet in the airplane. The power outlet is usually located in the arm of your seat, typically near the same location you use to plug in headphones. Please ask a flight attendant for the exact location of the outlet. [. . . ] Insert the Notebook Input Cord into the iGo everywhereMAX body. Tech note: When using iGo dualpower with this iGo adapter, the maximum power output is shared between both devices. If a device attached to iGo dualpower is not charging properly, it may need more charging power than can be delivered at that particular time. When this happens, the adapter will shut down (LED will turn off), and we recommend charging each device separately. Auto Cord 3. Select the appropriate power input cord (wall or auto/air) and insert into the iGo everywhereMAX body. 4. [. . . ]