User manual I-GO WALL 85

[. . . ] Always hold the plug when inserting or removing it. Select the correct tip for your notebook by reviewing the attached tip compatibility hang tag or going to www. iGo. com ­ using the wrong tip may damage your computer or cause it to malfunction. Unplug iGo wall85 from the power outlet each time you attach a new tip to the cable. Ambient operating temperature is -5ºC to 40ºC Storage temperature is -20ºC to 85ºC Environmental Requirements 4. [. . . ] Do not attempt to disassemble the adapter. It has no serviceable or replaceable parts inside. Voltage in the adapter can cause injury. If the adapter malfunctions, immediately discontinue use and contact iGo Product Support. So, you would like to power/charge an additional mobile electronic (ME) device?All you need is the included iGo dualpower accessory and the appropriate tip to power/charge your notebook and a ME device at the same time (additional tips sold separately). · Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. We are committed to providing our customers with first-class customer service and product support. You can receive help in a variety of ways: Sales/Customer Service: 1-888-205-0093 Technical Support: 1-800-474-7593 Web: www. iGo. com Product Support 10. Always use the appropriate cables and connectors supplied with your adapter as shown in this User Guide. Use of cables, connectors or other accessories not supplied with your product may result in injury or damage to your device. FCC Compliance for iGo dualpower® Accessory This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ©2002-2006 Mobility Electronics, Inc. Mobility Electronics, iGo and iGo dualpower are registered trademarks and powered up and connected is a trademark of Mobility Electronics, Inc. All other brand names and logos are trademarks or registered trademarks of their respective owners. Specifications are subject to change without notice. Protected by one or more of the following patents: 5, 347, 211, 6, 064, 177, 6, 700, 808, 6, 643, 158, 6, 650, 560, 6, 751, 109, 6, 775, 163 6, 791, 853, 6, 920, 056, 6, 937, 490 and 6, 976, 885. Other United States and foreign patents pending. A. AC input: DC output to notebook: Unit dimensions: Over-voltage protection Over-current limit Over-temperature protection Short circuit protection Safety Features Specifications Unit weight: Cord lengths: Notebook model not listed on enclosed compatibility chart Device is not charging when iGo dualpower is configured LED does not light but unit appears to power devices Issue Notebook is not charging LED does not light up * Peak output power is defined as the maximum achievable wattage, sustained for ten seconds or less, under the following specific conditions: · AC input: 120 VAC minimum · DC output: 18 VDC This equipment has been designed for connection to TN and IT power systems. Troubleshooting Compatibility is always being updated Tip not installed on Notebook Input Cord Light burned out Probable Cause(s) Possible Solution(s) No input or output power Check plug connector Check cable connections Check outlet circuit breaker or fuse No electricity to unit 100-230 VAC; 2A; 50/60 Hz Up to 70W continuous; 84W peak* 4. 05 x 2. 07 x 1. 27" (103 x 52. 5 x 32. 1mm) 6. 9oz (195. 61g) AC input-3. 0' (0. 91m); DC output-6. 0' (1. 83m) See www. iGo. com for current compatibility information Contact iGo customer service (see contact information on the back of this guide) Install tip on Notebook on Input Cord See solutions "Notebook is not charging" How to Use This iGo Wall Power Adapter Standard Wall Outlet: Plug the wall outlet cord into any standard wall outlet. Once connected, your battery will automatically charge regardless of whether your electronic device is turned on or off. Note:We recommend that you use iGo wall85 only with your device's batteries that meet or exceed the original manufacturer specifications. CAUTION: Like the power adapter that came with your electronic device, this iGo adapter may get warm to the touch during use. This is normal. Avoid placing your iGo adapter in direct sunlight or next to heat sensitive materials. Carrying case iGo notebook power adapter Package Contents 2-year limited warranty Warranty Thank you for purchasing an iGo mobile solution. Help us serve you better by taking a moment to register your product at www. iGo. com/registration. [. . . ] Insert the wall outlet cord into the iGo wall85 body. 4. Plug into the appropriate socket. The LED on the adapter will illuminate, indicating that power is available. If the LED is not lit, be sure to check all connections. [. . . ]