User manual IBM 3000 C200 Hardware Guide

[. . . ] Lenovo 3000 C200 Hardware Maintenance Manual September 2006 This manual supports: Lenovo 3000 C200 (MT 8922) Lenovo 3000 C200 Hardware Maintenance Manual Note Before using this information and the product it supports, be sure to read the general information under "Notices" on page 95. First Edition (September 2006) © Copyright Lenovo 2006. GOVERNMENT USERS ­ RESTRICTED RIGHTS: Our products and/or services are provided with RESTRICTED RIGHTS. Use, duplication or disclosure by the Government is subject to the GSA ADP Schedule contract with Lenovo Group Limited, if any, or the standard terms of this commercial license, or if the agency is unable to accept this Program under these terms, then we provide this Program under the provisions set forth in Commercial Computer Software­Restricted Rights at FAR 52. 227-19, when applicable, or under Rights in Data-General, FAR 52. 227. 14 (Alternate III). Contents Introduction . Strategy for replacing a hard disk drive . [. . . ] For how to remove the battery pack, see "1010 Battery pack" on page 46. For how to remove the DIMM slot cover, see "1070 DIMM slot cover" on page 51. Remove the DIMM. General descriptions 21 Related service information For how to remove the DIMM, see "1080 DIMM" on page 52. Reinstall the DIMM and the DIMM slot cover. Turn on the computer and wait until the POST ends. After the POST ends, the password prompt does not appear. (B) If an SVP has been set and is known by the servicer: 1. Turn on the computer; then, while the initial screen is displayed, press the Lenovo CareSM button. The System Restart Required window is displayed. The computer restarts, and the BIOS Utility screen opens. Select Security, using the cursor directional keys to move down the menu. Type the current SVP in the Enter Current Password field. then leave the Enter New Password field blank, and press Enter twice. In the Changes have been saved window, press Enter. Press F10; then, in the Setup confirmation window, select Yes . Note: For some models, the BIOS menu marked *1 is User Password. How to remove the hard-disk password Attention: If User only mode is selected and the user HDP has been forgotten and cannot be made available to the servicer, neither Lenovo nor Lenovo authorized servicers provide any services to reset the user HDPs or to recover data from the hard disk drive. The hard disk drive can be replaced for a scheduled fee. To remove a user HDP that has been forgotten, when the SVP and the master HDP are known, do the following: 1. Turn on the computer; then, while the initial screen is displayed, press the Lenovo Care button. The System Restart Required window is displayed. The computer restarts, and the BIOS Utility screen opens. Select Security, using the cursor directional keys to move down the menu. 22 MT 8922 Related service information 5. [. . . ] The furnishing of this document does not give you any license to these patents. You can send license inquiries, in writing, to: Lenovo (United States), Inc. 54 Research Triangle Park, NC 27709 U. S. A. Attention: Lenovo Director of Licensing LENOVO GROUP LTD. [. . . ]