User manual IBM 4232 PRINTER MODEL 302

[. . . ] 4232 Printer Model 302 User's Guide SA24-4386-01 4232 Printer Model 302 User's Guide SA24-4386-01 IBM Note!Before using this information and the product it supports, be sure to read the general information under "Notices" on page ix. | Second Edition (September 1994) | This major revision obsoletes and replaces SA24-4386-00 and Technical Newsletter | SN24-2028-00. Changes or additions to the text and illustrations are indicated by a | vertical line to the left of the change. Changes are made occasionally to the information herein; any such changes will be reported in subsequent revisions or Technical Newsletters. [. . . ] The Ready indicator goes on, and printing begins. The test prints samples using alignment values higher and lower than the default value. The print sample using the default value is indicated with an asterisk ( ). The alignment printout is complete when the Ready indicator goes off. * Chapter 1. Setting Up the 4232 Printer Model 302 1-107 The printer displays Bidirectional Adjustment 1-108 User's Guide Model 302 7. If the default value does not give the best print sample, press Scroll or Scroll until the printer displays the same number of arrows that were printed beside the best print sample line. Press Enter to set this as the new default value. The printer then prints another line to demonstrate the new default (you will need to load another form), and the test is complete. or Press Stop to end the test without changing anything and return to the Operator Print Tests menu. or Press Cancel Print to end the test, exit test mode, perform a partial reset, and have the printer display READY <A> Note: See Chapter 4, "Using the Operator Print Tests" for more information. Chapter 1. Setting Up the 4232 Printer Model 302 1-109 Unloading Forms To unload forms from the F3 forms device: 1. Remove the form from the top of the printer. 1-110 User's Guide Model 302 Removing the Document Insertion Device (F3) Note: If you are removing this forms device to install a different forms device, make sure you change the selected forms device in the Configuration Menu. To remove the F3 forms device, follow these steps: 1. If forms are in the printer, unload them (see "Unloading Forms" on page 1-110); then continue with Step 2 of this procedure. Then open the front paper door as follows: a. Pull the door up until it will not go any higher. Push the door back slightly to lock it in the open position. Access C over Paper Door Chapter 1. Setting Up the 4232 Printer Model 302 1-111 4. Push the bottom of the device toward the rear of the printer until it unlocks. Finger Grips 5. Grasp the top of the forms device and lift it out. To p o f F o rm s D evice Platen Rod 1-112 User's Guide Model 302 6. If you are removing the F3 forms device to install a different forms device, you must remove the lower forms guide. With a firm grasp, slide the lower forms guide to the right off the blue forms guide/forms sensor. [. . . ] Used to hold the print head and ribbon guide posts as they slide along the platen. The quality of printed output relative to existing standards and in comparisons with jobs printed earlier. The number of characters printed per unit of time. | | | | problem determination. The process of identifying the source of a problem; for example, a program component, a machine error, telecommunication facilities, user or contractor-installed programs or equipment, an environmental condition, such as a power loss, or a user error. R ready. [. . . ]