User manual IBM INTELLISTATION E PRO 6204

[. . . ] ® IntelliStation E Pro ® Types 6204 and 6214 User's Guide Welcome. . Thank you for buying an IBM IntelliStation E Pro computer. This User's Guide contains information for setting up, installing options, and preparing applications to run on your computer. This book also contains information regarding everyday use and solving problems. [. . . ] Do the following to install the U-bolt: 1. Review the safety precautions listed in "Safety information" on page vii. Turn off the computer and all attached devices. Disconnect all external cables and power cords; then remove the cover. See "Removing the side cover" on page 58 for details. Use a screwdriver to remove the two metal knockouts. Insert the U-bolt through the rear panel; then attach and tighten the nuts. Chapter 5. Thread the cable through the U-bolt and around an object that is not part of or permanently secured to the building structure or foundation, and from which the cable cannot be removed. Fasten the cable ends together with a lock. After you add the security cable, be certain it does not interfere with other cables connected to the computer. 6. Reconnect the external cables and power cords, and turn on the attached devices, and then the computer. 72 IBM® IntelliStation® E Pro: User's Guide Replacing the cover Do the following to replace the cover of the tower model: Note: If you removed the support bracket, reinstall it before you replace the cover. See "Removing the support bracket" on page 59 for details. Clear any cables that might impede the replacement of the cover. Install the side cover by placing it into position on the computer. Be certain the notches on the underside of the cover match up to the holes along the sides of the computer. Press down on the cover release latch button as you close the cover release latch to lock the cover. 3. If you have not done so already, make sure that the two front stabilizing feet are rotated outward so that they properly support the computer. Rotate each individual foot outward 90 degrees. Reconnect the external cables and power cords to the computer; then connect the power cords to electrical outlets. Turn on the attached devices; then turn on the computer. Connecting external options You can connect a number of optional external devices to the connectors on the rear and front of the computer. If your computer comes with a SCSI adapter installed, you can attach a SCSI storage expansion enclosure to your computer. Chapter 5. Installing options 73 To attach an external device: 1. [. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. [. . . ]