User manual ICOM IC-F29SR

[. . . ] To attach the jack cover: qqPlace the jack cover over the speaker-microphone To detach the jack cover: qqUnscrew the screws using a Phillips screwdriver. If you use the CS-F29SR cloning software (purchase separately), you can assign the functions described below to [TOP], [Upper], and [Lower]. NOTE: Refer to the instruction sheet that comes with the transceiver for the default settings of these keys. W hen a scan is started with the Power ON Scan or Automatic scan function, push this key to pause it. [. . . ] A beep sounds every time you push [Upper]. therefore , You can determine the current level setting by the increasing loudness of the beep that sounds. T o determine if you have selected a linked level, set [VOL] to minimum, then push [Upper] repeatedly, listening for the loudest beep (level 5). Pushing [Upper] once after the loudest beep will select 1 (Linked). Repeatedly push [Upper] to select the desired linked level. TtRotate [VOL] to turn OFF the power to exit the beep level adjustment mode. Setting the ringer level You can adjust the ringer level between 1 and 5, or 1 (linked) and 5 (linked). When a linked option is selected, you can adjust the ringer level by rotating [VOL]. EeWhile holding down [Lower], rotate [VOL] to turn ON the power and enter the ringer level adjustment mode. RrPush [Upper] to increase, or push [Lower] to decrease the ringer level as shown to the right. Therefore, you Can determine the current level setting by the increasing loudness of the beep that sounds. T o determine if you have selected a linked level, set [VOL] to minimum, then push [Upper] up to 10 times, listening for the loudest beep (level 5). Pushing [Upper] once after the loudest beep will select 1 (Linked). Repeatedly push [Upper] or [Lower] to select the desired linked level. TtRotate [VOL] to turn OFF the power to exit the ringer level adjustment mode. Setting the group code number dDCTCSS tone setting The transceiver is equipped with 50 CTCSS tones. CTCSS operation enables silent standby, since you will only receive calls from group members using the same CTCSS tone. WwSet [ROTARY SELECTOR] to any channel other Rotate [VOL] to turn ON the power. rrRotate [ROTARY SELECTOR] to select the desired Channel (1 to 16) that you want to assign the CTCSS tone to. TtHold down [Upper] until two beeps sound. YyPush [PTT] the necessary number of times to enter the ten's digit of the desired CTCSS tone number (grey column) as shown in the list below. IiPush [PTT] the necessary number of times to enter the one's digit of the desired CTCSS tone number (grey column) as shown in the list below. [. . . ] TtRotate [VOL] to turn OFF the power to exit the microphone gain adjustment mode. Setting the squelch level The squelch circuit mutes the received audio signal, depending on the signal strength. QqRotate [VOL] to turn the transceiver power OFF. WwSet [ROTARY SELECTOR] to any channel other than Channel 16. [. . . ]