User manual ICOM IC-F620

[. . . ] WORD NEVER allow children to touch the transceiver. NEVER expose the transceiver to rain, snow or any liquids. Other microphones have different pin assignments and may damage the transceiver. Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in the United states, the United Kingdom, Germany, France, Spain, Russia and/or other countries. [. . . ] y POWER SWITCH [POWER] Push to turn the power ON and OFF. · At power ON, a power-up alert tone sounds for about 1 sec. And the transceiver automatically starts scanning if the scan function had been activated before the power was turned OFF. u y t q AF VOLUME CONTROL KNOB Rotate the knob to adjust the audio output level. · Minimum audio level is pre-programmed. w LEFT UP/DOWN []/[] KEYS Push to select the talk group on the LTR or PassPort system. e FUNCTION DISPLAY Displays a variety of information, such as an operating channel text, talk group text. NOTE: The above functions depend on pre-programming. r RIGHT UP/DOWN [ ]/[ ] KEYS Push to select the operating system. Push [ ] key to send the most recently transmitted DTMF code number during transmitting. 1 u MICROPHONE CONNECTOR Connect the supplied microphone or optional DTMF microphone. NEVER connect non-specified microphones. The pin assignments may be different and the transceiver may be damaged. D MICROPHONE The supplied microphone has a PTT switch and a hanger hook. PANEL DESCRIPTION 1 I Function display qw e r t y u i o u BELL INDICATOR Blinks when the individual call is received. !0 i PHONE INDICATOR Appears when the phone channel is selected. o SCAN INDICATOR Appears when the scan function is set in the channel, and blinks while scanning. !0 ALPHANUMERIC DISPLAY Displays an operating channel text, talk group text, etc. q TRANSMIT INDICATOR Appears while transmitting. w BUSY INDICATOR Appears while the channel is busy. e SIGNAL STRENGTH INDICATOR Indicates relative signal strength level. Does not appear when the transceiver is out of the service area when operating on the PassPort system. r LOW POWER INDICATOR Appears when low output power is selected. t MONITOR SWITCH INDICATOR Appears when the monitor switch is pushed. y COMPANDER INDICATOR Appears when the compander function is activated. 2 2 CONNECTION AND MAINTENANCE I Rear panel and connection Optional speaker (SP-22) q Antenna t red: + w r Optional cable (OPC-617) e black: Supplied DC power cable NEVER connect to a 24 V battery. 12V Battery Note: Use the terminals for the cable connections. Crimp Solder 3 CONNECTION AND MAINTENANCE q MICROPHONE HANGER Connect the supplied microphone hanger to the vehicle's ground. w ANTENNA CONNECTOR Connects to an antenna. Ask your dealer about antenna selection and placement. e DC POWER RECEPTACLE Connects to a 12 V DC battery. r OPTIONAL CABLE (OPC-617) Connect an external modem unit, LCD backlight control, etc. [. . . ] 1020 codes) UT-109 UT-110 HM-100TN DTMF MICROPHONE Hand microphone with a DTMF keypad. 9 SAFETY TRAINING INFORMATION Your Icom radio generates RF electromagnetic energy during transmit mode. This radio is designed for and classified as "Occupational Use Only", meaning it must be used only during the course of employW ARN ING ment by individuals aware of the hazards, and the ways to minimize such hazards. This radio is NOT intended for use by the "General Population" in an uncontrolled environment. · For compliance with FCC and Industry Canada RF Exposure Requirements, the transmitter antenna installation shall comply with the following two conditions: 1. [. . . ]