User manual ICOM IC-H10

[. . . ] NEVER hold the transceiver so that the antenna is very close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 2 to 4 in. (5 to 10 cm) away from the lips and the transceiver is vertical. NEVER operate the transceiver with a headset or other audio accessories at high volume levels. [. . . ] · Be sure to attach the spacer (Spacer B/C) to the adapter (Spacer A) Spacer A with the orientation as illustrated in the diagram at right. · Attach the spacer (Spacer B/C) to the adapter with the orientation of the stamp " Check orientation and Spacer B/C " pointing up. NOTE: Push the notch carefully when remove the spacer from the adapter. 8 3 BATTERY PACKS D Rapid charging with the BC-121+AD-94 (#11) The optional BC-121 allows up to 6 battery packs to be charged simultaneously. The following are additionally required. · Six AD-94 (#11) (Some versions require additional AD-99s). · An AC adapter (may be supplied with the BC-121 depending on version). Turn power OFF. AC adaptor (purchased separately) AD-99 MULT I-CHA RGER Charge indicator (each indicator functions independently) D Regular charging with the BC-146 The optional BC-146 pro- Turn power OFF. vides regular charging of optional battery pack with/ without transceiver. The following is additionally required: · An optional AC adapter. (A charging spacer is supplied with BC-146. ) Check orientation for correct charging. (Insert together with charging adapter. ) BC-146 9 BATTERY PACKS 3 ` Charging NOTE Prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. · Recommended temperature range for charging: +10°C to +40°C (50°F to 140°F). · Use the supplied charger or optional charger (BC-119/BC-121/BC144 for rapid charging, BC-146 for regular charging) only. · Priority channel is automatically selected. 12 4 PROGRAMMABLE FUNCTIONS D SCAN FUNCTION The scan function allows you to search a pre-programmed group of channels for signals. Push the [Scan] switch to start/stop scan. · Scan pauses on a channel when receiving a signal. · "Lockout SCAN" (pre-programmed list SCAN) or "Priority SCAN" can be pre-programmed. · When the "Power-save function" is activated, the transceiver checks all pre-programmed channels then returns to the "Powersave function" again. D HIGH/LOW POWER OUTPUT This function selects high or low power for a channel. Push the [High/Low] switch to toggle between high and low power. 13 PROGRAMMABLE FUNCTIONS 4 D MONITOR AUDIBLE FUNCTION The monitor function allows you to open the transceiver's squelch manually to check whether a channel is busy or not. The transceiver has 2 conditions for receive standby: Audible condition: This condition mutes audio ONLY when no carrier is present. You can receive (or monitor) any signals on a channel. · Push and hold the [Moni], switch to select the audible condition. Any audio mute functions are cancelled while pushing the [Moni] switch. [. . . ] In such a case, memory contents may be lost. Cloning must then be repeated. 20 7 OPTION ` Options D BATTERY PACKS · BP-208 BATTERY CASE Allows a set of Alkaline batteries to operate the handheld when charging the rechargeable battery or in emergencies, etc. · BP-209 Ni-Cd BATTERY PACK 7. 2 V/1100 mAh Ni-Cd battery pack, allows more than 8 hours operation. · BP-210 Ni-MH BATTERY PACK 7. 2 V/1650 mAh Ni-MH battery pack, allows approx. [. . . ]