User manual ICOM IC-M127EURO

[. . . ] · American National Standards Institute (C95. 1-1992), IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz. · American National Standards Institute (C95. 3-1992), IEEE Recommended Practice for the Measurement of Potentially Hazardous Electromagnetic Fields­ RF and Microwave. · The following accessories are authorized for use with this product. Use of accessories other than those specified may result in RF exposure levels exceeding the FCC requirements for wireless RF exposure. ; Belt Clip (MB86/103), Rechargeable Ni-Cd Battery Pack (BP-225) and Alkaline Battery Case (BP-223). [. . . ] NOTE: The transceiver has a power save function to conserve the battery power. The power save function activates automatically when no signal is received for 5 sec. To prevent accidental prolonged transmission, etc. , the ICM90 has a time-out timer function. This timer cuts a transmission OFF after 5 min. of continuous transmission. 4 r Push [Hi/Lo· ] to select the output power if necessary. y Push to transmit u Release to receive MIC/SP - "LOW" appears when low power is selected; "MID" appears when middle power is selected; no indication when high power is selected. - Choose low power to conserve battery power, choose high power for longer distance communications. - Some channels are for low power only. q Power ON e Set volume Speaker t Push and hold [PTT] to transmit, then speak into the microphone. - The [TRANSMIT/RECEIVE] indicator lights red while transmitting. - Channel 70 cannot be used for transmission. Microphone w Set the squelch level e Set volume r Set channel w Set the squelch level t Set output power y Release [PTT] to receive. 9 4 BASIC OPERATION I Call channel programming The call channel switch is used to select Channel 9 by default, however, you can program your most often-used channel in each channel group for quick recall. q Push [CH/WX·U/I/C/L] for 1 sec. to several times to select the desired channel group (USA, INT, CAN) to be programmed. In addition, the "Weather alert" and "Auto scan" functions are available for scanning. These functions can be activated simultaneously, depending on the settings on the SET mode. 17, 18) PRIORITY SCAN CH 01 CH 02 Set the tag channels (scanned channel) before scanning. Clear those tag channels which are not needed or inconveniently stop scanning, such as digital communications. Choose priority or normal scan on the SET mode. 17) NORMAL SCAN CH 01 CH 02 WX* CH 16 CH 03 WX* CH 03 CH 05 CH 04 CH 05 CH 04 * Previously selected weather channel when weather alert function is ON Priority scan searches through all tag channels in sequence while monitoring Channel 16. When a signal is detected on Channel 16, scan pauses until the signal disappears; when a signal is detected on a channel other than Channel 16, scan becomes dualwatch until the signal disappears. 12 * Previously selected weather channel when weather alert function is ON. Normal scan, like priority scan, searches through all tag channels in sequence. However, unlike priority scan, Channel 16 is not checked unless Channel 16 is set as a tag channel. SCAN OPERATION 5 I Setting tag channels For more efficient scanning, add desired channels as tag channels or clear the tag for unwanted channels. Non-tag channels will be skipped during scanning. [. . . ] w Push [Y]/[Z] to select the desired channel. Push [Hi/Lo ] for 1 sec. to turn the lock function ON and OFF. e Push [Y]/[Z] to select the desired condition. e Push [SCAN DUAL] for 1 sec. to start dualwatch or tri-watch (depending on SET mode). r To cancel dualwatch/tri-watch, push [SCAN DUAL] again. n SQUELCH LEVEL (p. [. . . ]