User manual ICOM IC-UR8050

[. . . ] We want to take a couple of moments of your time to thank you for making your IC-UR8050 your radio of choice, and hope you agree with Icom's philosophy of "technology first. " Many hours of research and development went into the design of your IC-UR8050. IMPORTANT READ ALL INSTRUCTIONS carefully and completely before using the transceiver. SAVE THIS INSTRUCTION MANUAL-- This instruction manual contains important operating instructions for the IC-UR8050. EXPLICIT DEFINITIONS DEFINITION Personal injury, fire hazard or electric shock R WARNING!CAUTION NOTE Equipment damage may occur. No risk of personal injury, fire or electric shock. WORD D FEATURES Diversity reception DV (Digital Voice) with GPS operation (Optional UT-123 is required) capabilities V/V, U/U simultaneous receive capability Independent controls for both left and right receivers Separate controller for flexible installation Remote control microphone included i Icom, Icom Inc. [. . . ] eRotate [DIAL] to select "DV VOICE MEMO, " then push [MAIN·BAND]. rRotate [DIAL] to select "REPLY VOICE, " then push [MAIN·BAND]. Automatic reply function The automatic reply function replies to calls by a station that specified your call sign. Two methods of replying are available: one is making a reply call with your own call sign, and other one is making a reply call with reply voice audio that has been recorded in DV voice memory. D Automatic reply function setting q Push [F· ] to display the function guide. wPush [MENU](V/MHz·SCAN) (Right band's) to display the "MENU" screen. eRotate [DIAL] to select "DV SET MODE, " then push [MAIN·BAND]. rRotate [DIAL] to select "AUTO REPLY, " then push [MAIN·BAND]. t Rotate [DIAL] to select the desired reply condition. OFF : Deactivate the automatic reply function. (default) ON : Reply to the call with your own call sign. VOICE : Reply to the call with the recorded voice memory. · Bar meter is displayed when the reply voice has already been recorded. tWhile pushing and holding [PTT], speak into the microphone. · Up to 10 seconds of message is recordable. · The recording stops after 10 second or when [PTT] is released. 38) and " Digital repeater operation" (p. wRefer to the instructions for low-speed data communication application. e To transmit data. · At the same time as voice audio, push and hold [PTT] to transmit while sending data from the PC. · Under computer control, see Transmission condition setting at right. · "L" appears when the packet loss occurs. 57 DV MODE OPERATION (Optional UT-123 is required) 5 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 58 DV voice memory D Transmission condition setting q Push [F· ] to display the function guide. wPush [MENU](V/MHz·SCAN) (Right band's) to display the "MENU" screen. eRotate [DIAL] to select "DV SET MODE, " then push [MAIN·BAND]. rRotate [DIAL] to select "DV DATA TX, " then push [MAIN·BAND]. t Rotate [DIAL] to select the desired transmission condition. PTT : The entered text data in the Terminal Window (buffer screen) is transmitted when [PTT] is pushed. (default) AUTO : The entered text data in the Terminal Window (buffer screen) is automatically transmitted when text is entered. [. . . ] Turn power OFF and disconnect the transceiver from power source before opening the top cover. Otherwise an electric shock or damage to the transceiver may occur. Install the optional UT-123 as following procedures. q Unscrew 10 screws from the top cover of the main unit then remove the top cover. [. . . ]