User manual IDEAL 61534

[. . . ] Non-Contact Voltage Test Point the receiver's nose towards a live AC receptacle or power cord. Once an AC Voltage field of > 50V is sensed, the receiver will switch to Voltage Sensor mode. The red LED remains lit and the receiver will audibly beep. The beeping speed will increase when the receiver is moved closer to the AC power source, and slows when the receiver is moved further away. [. . . ] BATTERY REPLACEMENT: Remove battery cover. Insert new 9V battery into battery compartment and re-install battery cover. ND 5416-1 61-534 Instructions 7/19/05 11:58 AM Page 2 Verifying Receptacles for Correct Wiring: Plug the transmitter into a standard 120 Vac receptacle. The three LED lamps on the transmitter will indicate the wiring configuration, the label on the transmitter indicates each sequence. Consult the GFCI manufacturer's installation instructions to determine that the GFCI is installed in accordance with the manufacturer's specifications. Check for correct wiring of receptacle and all remotely connected receptacles on the branch circuit. If it does not ­ do not use the circuit ­ consult an electrician. Then, insert the GFCI tester into the receptacle to be tested. Activate the test button on the GFCI tester for a minimum of 6 seconds when testing the GFCI condition. Visible indication on the GFCI tester must cease when tripped. If the tester fails to trip the GFCI, it suggests: A wiring problem with a totally operable GFCI, or b) proper wiring with a faulty GCFI. Consult with an electrician to check the condition of the wiring and GFCI. Caution: When testing GFCIs installed in 2-wire systems (no ground wire available), the tester may give a false indication that the GFCI is not functioning properly. If this occurs, recheck the operation of the GFCI using the test and reset buttons. The GFCI button test function will demonstrate proper operations. NOTE: · All appliances or equipment on the circuit being tested should be unplugged to help avoid erroneous readings. · Not a comprehensive diagnostic instrument but a simple instrument to detect nearly all probable common improper wiring conditions. · Refer all indicated problems to a qualified electrician. · Will not indicate quality of ground. · Will not detect 2 hot wires in circuit. · Will not detect a combination of defects. · Will not indicate reversal of grounded and grounding conductors. SPECIFICATIONS: Operating Range: 100-250VAC Operating Frequency: 47-63Hz Maximum Load: 18A (4ms) at 120VAC, 200mW max, at 120VAC Duty Cycle: Max: 4mS every 16. 6mS (continuous), (. 24%) Weight (excluding battery): Transmitter approx 50gr. , Receiver approx. [. . . ] Saque la pila vieja, y reemplácela por una pila normal de 9 VCC. Modalidad inactiva Siempre que la pila esté en buenas condiciones, el receptor pasará a la modalidad inactiva. El LED del receptor brillará con una luz amarilla y el receptor comprobará continuamente si hay señales activas. Prueba de voltaje sin contacto Apunte el extremo del receptor hacia un receptáculo o cordón de alimentación de CA. [. . . ]