User manual IDK MULTIMEDIA BC-838 PLUS

[. . . ] The IR Indicator will blink when keys are pressed both during normal use and in programming mode. (1) IR (Infra-red) Indicator The IR Indicator animates when IR is being "sent" or "received". The IR Indicator will blink when keys are pressed both during normal use and in programming mode. (2) POWER key The POWER key controls the same function as on your original remote control. [. . . ] The LCD shown as SUCCESS and the BC-838 Plus is now ready to operate your TV. In any cases if you need to leave the Auto All Search, just press the [ESC] key to exit, the LCD will be shown as EXIT and back to normal operation mode. To program other equipment, repeats the Steps 1-11 for your VCR, DVD, CD, ASAT, DSAT, CBL and or your second TV or VCR or SAT, etc. Press the [SET] key to for 3 seconds Press & release the [CH+] key Press the [SET] key to save the working code This Group Search method checks all its preprogrammed codes to find the code that will operate your equipment. Make sure your TV is switched on (not on standby). Press the [SET] key to for 3 seconds and the LCD will be shown CODE SETUP. Press & release the [CH+] key once to view the CODE SRCH page. Upon the LCD shown CODE SRCH, press the [SET] key once, the LCD shown as TV ALL SRCH. Once you selected, press the [SET] once, the LCD shown as GROP 1 TV--001 and the BC-838 Plus is now performed the Group Search count from the code you set up before, for example TV 001. Press the [SET] key to save the working code. The LCD shown as SUCCESS and this indicates that the BC-838 Plus is now set to your TV. In any cases if you need to leave the Group Search, just press the [ESC] key to exit, the LCD will be shown as EXIT and back to normal operation mode. To program other equipment, repeats the Steps 1-9 for your VCR, DVD, CD, ASAT, DSAT, CBL, and or your second TV or VCR or SAT. Press the [SET] key to for 3 seconds Press & release the [CH+] key Press the [SET] key to save the working code The BC-838 Plus comes with a complete library of pre-programmed codes. After you have set up the BC-838 Plus for your device, you may find that there are one or more keys that you had on the original remote control, which do not have a place on the BC-838 Plus keypad. The BC-838 Plus offers a special learning feature that allows you to copy almost any function from your original remote control onto the keypad of the BC-838 Plus. Except the [SET] key and Device mode keys. before you start : · Make sure your original remote control is working correctly. ⷠMake sure neither your BC-838 Plus, nor your original remote control is pointing at your device. To Learning (direct): For example: To copy the "PIP" function from your original TV remote control key of your BC-838 Plus. Make sure the ends which you normally point at your device are facing each other. Point the original remote to the front center head of the BC-838 Plus (see picture below). [. . . ] Press the [SET] key to for 3 seconds Press & release the [CH+] key for seven (7) times Press the [SET] key to for 3 seconds and the LCD will be shown CODE SETUP. Press & release the [CH+] key for seven (7) times to view the ALARM SET page. Upon the LCD shown as ALARM SET, press the [SET] key once. Press the [SET] key once, the LCD shown as SUCCESS and back to normal operation and the symbol of "ALARM" will be cancelled. [. . . ]