User manual IHOME IP1

[. . . ] Turn the Bumper Adjust Knob on the back of the unit until the bumper touches the back of your iPod/iPhone. Bumper should not push your iPod/iPhone too far forward. Your iPhone or iPod will charge while docked. Listening to iPhone or iPod Press the Power Button to turn the unit on. Press Play on iPhone or iPod to listen to music. [. . . ] See above for software upgrade information. Refer to your iPhone or iPod user guide for details on how to perform a reset. 7 TROUBLESHOOTING Symptom Erratic performance Possible reason External interference Solution Move unit away from potential sources of external interference such as computers, modems, wireless devices (routers) or fluorescent light. Turn volume up Turn volume down If the iPhone/iPod original sound file (MP3) is old or of poor quality, distortion and noise are easily noticed with high-power speakers. Try a different audio source such as an audio CD. Turn Bongiovi DPS off if necessary. No sound Sound distorted Volume is too low Volume is too high Sound source is distorted Bongiovi DPS and/or eq settings are set too high iPod/iPhone doesn't charge up iPhone/iPod is locked up/ frozen iPhone/iPod battery has problem iPhone/iPod is not docked properly Please make sure your iPhone/iPod is working properly before docking into the unit. Please refer to your iPhone/iPod manual for details. Remove your iPhone/iPod from the dock and check for obstruction on the connectors in the dock and on your iPhone/iPod. 8 IMPORTANT SAFETY TIPS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. Water and Moisture ­ The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. Ventilation ­ The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings. Heat ­ The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. Power Sources ­ The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Power-Cable Protection ­ Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. Cleaning ­ The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions. Objects and Liquid Entry ­ Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. Attachments ­ Do not use attachments not recommended by the product manufacturer. [. . . ] This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances. Maintenance · Place the unit on a level surface away from sources of direct sunlight or excessive heat. [. . . ]