User manual IIYAMA PROLITE B2008HDS

[. . . ] USER MANUAL ENGLISH Thank you very much for choosing the iiyama LCD monitor. We recommend that you take a few minutes to read this comprehensive manual carefully before installing and switching on the monitor. Please keep this manual in a safe place for your future reference. AB52 ENGLISH CE MARKING DECLARATION OF CONFORMITY This LCD monitor complies with the requirements of the EC Directive 2004/108/EC "EMC Directive" , 2006/95/EC "Low Voltage Directive" and 2009/125/EC "ErP Directive". The electro-magnetic susceptibility has been chosen at a level that gives correct operation in residential areas, business and light industrial premises and small-scale enterprises, inside as well as outside of the buildings. [. . . ] It may cause damage or break the LCD screen. Careful attention is required not to catch your fingers or hands when you change the angle. Do not tilt the post beyond 20 degrees except when repacking the monitor in its box. To do so may cause the monitor to fall over and break. BEFORE YOU OPERATE THE MONITOR 11 ENGLISH OPERATING THE MONITOR To create the best picture, your iiyama LCD monitor has been preset at the factory with the COMPLIANT TIMING shown on page 28. You are also able to adjust the picture by following the button operation shown below. For more detailed adjustments, see page 18 for SCREEN ADJUSTMENTS. Press the ENTER Button to start the On Screen Display feature. There are additional Menu items which can be switched by using the / Buttons. Main Menu Auto Adjust Luminance Language Recall Miscellaneous Input Select Audio ENGLISH Geometry Color OSD Select the Menu item which contains the adjustment icon relating to the adjustment you want to make. Then, use the / Buttons to highlight the desired adjustment icon. / Buttons to make the appropriate Press the EXIT Button to leave the menu, and the settings you just made would be automatically saved. For example, to correct for vertical position, select Menu item of Geometry and then press the ENTER Button. Then, select (V. Position) by using the / Buttons. Main Menu Auto Adjust Luminance Geometry Color OSD Language Recall Geometry H. Position Miscellaneous Input Select Audio 50 50 50 50 Pixel Clock Phase An adjustment page appears after you press the ENTER Button. Then, use the / Buttons to change the vertical position settings. The vertical position of the overall display should be changing accordingly while you are doing this. Press the EXIT Button lastly, it ends, any changes are saved in the memory. Geometry V. Position 50 NOTE When button operations are aborted during adjustment, On-Screen Display disappears when the time set for the OSD Time has passed. Also, press the EXIT button to quickly turn off the On-Screen Display. Any changes are automatically saved in the memory when the On Screen Display disappears. Turning off the power should be avoided while using the Menu. Position, Pixel Clock and Phase are saved for each signal timing. Except for these adjustments, all other adjustments have only one setting which applies to all signal timings. 12 OPERATING THE MONITOR ADJUSTMENT MENU CONTENTS Auto Adjust Adjustment Item Auto Adjust * Only Analog Input Problem / Option Button to Press Direct Adjust H. Position, Pixel Clock and Phase automatically. * For best results, use the Auto Adjust in conjunction with the adjustment pattern. See page 18 for SCREEN ADJUSTMENTS. Direct You can skip the Menu items and display an adjustment scale directly by using the following button operations. [. . . ] If the monitor does not get a picture, skip to 2. Consult the following items if you cannot find an appropriate adjustment item in OPERATING THE MONITOR or if the problem persists. If you are experiencing a problem which is not described below or you cannot correct the problem, discontinue using the monitor and contact your dealer or iiyama service center for further assistance. ENGLISH Problem The picture does not appear. Check (Power indicator Power Cable is firmly seated in the socket. The does not light up. ) Power Switch is turned ON. [. . . ]