User manual IIYAMA E2607WS

[. . . ] USER MANUAL ENGLISH DEUTSCH FRANÇAIS Thank you very much for choosing the iiyama LCD monitor. We recommend that you take a few minutes to read carefully through this brief but comprehensive manual before installing and switching on the monitor. Please keep this manual in a safe place for your future reference. NEDERLAND POLSKI iiyama | Servicecard Dear user, we congratulate you on the purchase of your iiyama LCD. All iiyama LCD monitors comply with the ISO13406-2 standard for pixel defects. For details on warranty and locally used pixel policies that apply directly after installation of your product please check the iiyama website. To report a fault, please contact your local support centre found at www. iiyama. com/service Things to check before you call the iiyama information line | if the power cable is connected securely and turned on? [. . . ] It may cause damage or break the LCD screen. Carefulattentionisrequirednottocatchyourfingers or hands when you change the angle. Do not tilt the post beyond 20 degrees except when repacking the monitor in its box. To do so may cause the monitor to fall over and break. 8 BEFORE YOU OPERATE THE MONITOR OPERATING THE MONITOR To create the best picture, your iiyama LCD monitor has been preset at the factory with the COMPLIANT TIMING shown on page 21. You are also able to adjust the picture by following the button operation shown below. For more detailed adjustments, see page 14 for SCREEN ADJUSTMENTS. Press the Menu Button to start the On Screen Display feature. There are additional Menu items which can be switched by using the / Buttons. Main Menu Auto Image Adjust Contrast/Brightness Input Select Color Adjust Information Manual Image Adjust Setup Menu Memory Recall 1 : Exit 2 : Select Select the Menu item which contains the adjustment icon relating to the adjustment you want to make. Then, use the / Buttons to highlight the desired adjustment icon. adjustment or setting. Press the Select Button again. Use the / Buttons to make the appropriate For example, to correct for vertical position, select Menu item of Image Adjust and then press the Select Button. / V. Position) by using the / Buttons. Main Menu Auto Image Adjust Contrast/Brightness Input Select Audio Adjust Color Adjust Information Manual Image Adjust Setup Menu Memory Recall 1 : Exit 2 : Select 1 : Exit 2 : Select Manual Image Adjust Horizontal Size H. /V. Position Fine Tune Sharpness Video Mode Adjustment OptiColor Mode An adjustment page appears after you press the Select Button. Then, use the / Buttons to change the vertical position settings. The vertical position of the overall display should be changing accordingly while you are doing this. NOTE When button operations are aborted during adjustment, On-Screen Display disappears when the time set for the OSD Time Out has passed. Also, press the Menu button to quickly turn off the OnScreen Display. Any changes are automatically saved in the memory when the On Screen Display disappears. Turning off the power should be avoided while using the Menu. Position, H. Size and Fine Tune are saved for each signal timing. Except for these adjustments, all other adjustments have only one setting which applies to all signal timings. OPERATING THE MONITOR 9 ADJUSTING ENGLISH Audio Adjust ADJUSTMENT MENU CONTENTS Auto Image Adjust Adjustment Item Auto Image Adjust * Only Analog input Problem / Option Button to Press Adjust H. Position, H. Size and Fine Tune automatically. ENGLISH NOTE Thescreenbecomesdarkforapproximatelyfivesecondsduringtheadjustment. * For best results, use the Auto Adjust in conjunction with the adjustment pattern. See page 14 for SCREEN ADJUSTMENTS. Contrast/Brightness Adjustment Item Contrast*3 Brightness *1, 3 ACR*2 ECO Problem / Option Too dull Too intense Too dark Too bright On Off On Off Increased contrast ratio typical contrast ratio Brightness of back light is reduced. [. . . ] (Power indicator ThePowerCableisfirmlyseatedinthesocket. does not light up. ) The Power Switch is turned ON. Please check with another piece of equipment. (Power indicator is blue. ) If the blank screen saver is in active mode, touch the keyboard or the mouse. [. . . ]