User manual IIYAMA T1530SR

[. . . ] USER MANUAL ENGLISH DEUTSCH FRANCAIS NEDERLANDS Thank you very much for choosing the iiyama LCD monitor. We recommend that you take a few minutes to read carefully through this brief but comprehensive manual before installing and switching on the monitor. Please keep this manual in a safe place for your future reference. FCC DECLARATION OF CONFORMITY Model Number: PLT1500 / PLT1700 / PLT1900 The result of electromagnetic emission has been evaluated by Compliance Certification Service Inc. This device complies with Part 15 of the FCC Rules. [. . . ] Available for ProLite T1730SR and ProLite T1930SR only. Available for ProLite T1530SR and ProLite T1730SR only. Available for ProLite T1930SR only. BEFORE YOU OPERATE THE MONITOR 6 ENGLISH CONNECTING YOUR MONITOR A Ensure that both the computer and the monitor are switched off. B Connect the computer to the monitor with the Signal Cable. C Connect the computer to the monitor with the RS-232C Cable or the USB Cable. D Connect the monitor to the audio equipment with the Audio Cable when using the audio features. E Connect the Power Cable to the monitor first and then to the power supply. NOTE The signal cables used for connecting the computer and monitor vary by the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a special cable is required please contact your local iiyama dealer or regional iiyama office. For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama office for a suitable adaptor. Make sure you tighten the finger screws at each end of the Signal Cable and the RS232C Cable. Don't connect the RS-232C cable and the USB cable to the computer at the same time. [Example of Connection] < Back > ENGLISH Power Cable (Accessory)*2 AC Adapter *1 (Accessory) Power Cable (Accessory)*1 RS-232C Cable (Accessory) USB Cable (Accessory) Audio Cable (Accessory) DVI-D Signal Cable (Accessory) D-Sub Signal Cable (Accessory) Computer *1 Available for ProLite T1530SR only. *2 Available for ProLite T1730SR and ProLite T1930SR only. 7 BEFORE YOU OPERATE THE MONITOR COMPUTER SETTING Signal Timing Change to the desired signal timings listed on page 21 in COMPLIANT TIMING. Windows 95/98/2000/Me/XP/Vista Plug & Play The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs on Windows 95/98/2000/Me/XP/Vista by connecting the monitor to DDC2B compliant computer with the Signal Cable supplied. Windows 95/98/2000/Me/XP Monitor Information File for iiyama monitors may be necessary for your computer and obtained via the Internet, using the address: http://www. iiyama. com NOTE For additional information on how to download the driver for your monitor, please access one of the internet sites noted above. Monitor Drivers are not required in most cases for Macintosh or Unix operating systems. For further information, please contact your computer dealer first for advice. Procedure for turning ON the Power Switch Turn ON the monitor first, and then the computer. [. . . ] Perform the adjustments described in OPERATING THE MONITOR, depending on the problem you have. If the monitor does not get a picture, skip to 2. Consult the following items if you cannot find an appropriate adjustment item in OPERATING THE MONITOR or if the problem persists. If you are experiencing a problem which is not described below or you cannot correct the problem, discontinue using the monitor and contact your dealer or iiyama service center for further assistance. [. . . ]