User manual IMG STAGE LINE TWIST-252

[. . . ] We wish you much pleasure with your new "img Stage Line" unit. With these operating instructions you will be able to get to know all functions of the unit. By following these instructions false operations will be avoided, and possible damage to yourself and your unit due to improper use will be prevented. Thus you will always be able to see the operating elements and connections described. [. . . ] The unit must have a minimum distance of 1 m to adjoining surfaces and the air vents at the housing must not be covered in any case. Pay in any case attention to a sufficient distance to easily flammable material or material sensitive to heat. If the unit is installed as a suspended load above persons, it must additionally be secured (e. Screw the supplied safety lug into the thread jack in the centre of the lower side of the unit and attach the safety rope to it. Fix the other end of the safety rope in such a way that the maximum falling distance of the unit is 20 cm. The light effect unit is supplied without lamp. a discharge lamp of type MSD 250 W with a base GY 9 , 5 is required. The following lamp may be used from the "img Stage Line" product range: Never touch the glass bulb of the lamp with your fingers!Finger marks reduce the light intensity and burn in. As soon as the unit is connected to the mains voltage, the POWER switch (7) lights up. While doing this, the display (8) shows the software version. Then the TWIST-252 is ready for operation. After operation, switch off the unit with the POWER switch. note: A discharge lamp serves as a light source. If the unit is only shortly switched off or disconnected from the power supply only for a short time, the lamp does not immediately light up again. It must cool down for some time to be able to ignite again. If no DMX control signal is present at this input, the yellow LED MASTER (12) lights up and the display (8) signalizes (Show 1) or (Show 2). For the music control switch off the function Blackout via the menu or with the remote control LC-3 (button STAND BY), otherwise the panning head remains in its initial position and the light beam is stopped down. A) Press the button MENU (9) four times so that the display shows (blackout mode). then the selected operating mode reappears. If the button ENTER is not actuated within 8 seconds, the unit switches back to the previous adjustment. E) To start the programme sequence, shortly switch the unit off and on again with the POWER switch (7). [. . . ] The adjusted start address is always displayed as soon as control signals are received from the DMX control unit. Blackout mode blackout on (yes blackout) If no DMX control signal is present at the jack DMX IN (14), the panning head goes to the initial position and the iris is closed. Blackout off (no blackout) A music control only by the microphone (17) is possible. Colour mode single-coloured (normal) The colour disk locks into place exactly at one colour. [. . . ]