User manual INDESIT B33FNFUK

[. . . ] That the inlet and draining pipes are connected correctly. Never use hoses that have already been used, always use the new ones provided with your machine; 3. That the washing machine is levelled properly; something worth checking to aid the performance of your washing machine; 4. That the drum's fixing screws have been removed from the back of the washing machine; 2. [. . . ] Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washing machine does not load water, it cannot start a wash cycle. select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is showing an anomaly. But where did all the water go? Simple: with the new Indesit technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. And, on top of that, you are also saving electricity. The washing machine fails to fill with water. RIGHT Turn off the water supply after use. This will eliminate the possibility of leakage. Always leave the appliance door ajar to avoid bad odours. Clean the appliance's exteriors gently. To clean the exteriors and the rubber parts of the appliance, always use a soft cloth dipped in warm and soapy water. WRONG Leave the washing machine plugged in while cleaning. Even during maintenance, the appliance should always be unplugged. Is the "Anti-crease" function -where provided enabled?This function requires manual selection for draining. To check it, turn off the water supply, unplug the washing machine and follow the instructions on page 12, or call for technical assistance. Too much foam. Is the detergent appropriate for machine washing?Check whether the definition on its label reads "for machine wash" or "hand and machine wash", or any other similar wording. An excessive amount of detergent, besides producing too much foam, does not guarantee a more effective wash, and causes scaling in the internal parts of the appliance. If, despite all checks, the washing machine fails to function and the problem persists, call your nearest authorised Customer Service Centre, providing the following information: - the nature of malfunction - the model type no. . . . . ) - the serial number (S/N . . . . ) This information can be found on the data plate situated at the back of the washing machine. The washing machine leaks. Is the metal ring of the inlet hose properly attached?Turn off the water supply, unplug the appliance and try tightening its attachment without forcing it. Turn off the water supply, unplug the appliance and try tightening its attachment. Excessive vibration during the spin cycle. Have all transit screws been removed durind installation?See the following page on installation procedures. Has the washing machine been levelled correctly? [. . . ] When you use your washing machine, water pressure is very strong and a cracked tube could easily split open. Instructions for installation and use 12 Important for the safe use of your washing machine Your safety and that of your family Read these instructions and all the information in this manual carefully: they are an important source, not only of numerous useful tips, but also of vital information on safety, use and maintenance. the machine should not be installed in an outdoor environment, not even when a roof shelters the area, because it may be very dangerous to leave it exposed to rain and thunderstorms. It must only be used by adults and exclusively for washing clothes following the instructions provided in this manual. Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. [. . . ]