User manual INDESIT BWD 71252

[. . . ] 12 Instructions for use WASHING MACHINE Contents Installation, 14-15 GB English Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data GB Care and maintenance, 16 Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 17 General safety Load balancing system Disposal BWD 71252 Description of the washing machine and starting a wash cycle, 18-19 Control panel Indicator lights Starting a wash cycle Wash cycles, 20 Push & Wash Table of wash cycles Personalisation, 21 Setting the temperature Setting the spin speed Functions Detergents and laundry, 22 Detergent dispenser drawer Preparing the laundry Garments requiring special care Troubleshooting, 23 Service, 24 13 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] The display will show the maximum duration of the cycle chosen, which may decrease after several minutes, since the effective duration of the programme varies depending on the wash load and the settings chosen. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle. At the end of the wash cycle the END indicator light will switch on. The door can be opened once the DOOR LOCK indicator light turns off (wait approximately 3 minutes). Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washing machine off by pressing the ON/OFF button. 19 Wash cycles GB Push & Wash This function allows for starting a wash cycle even when the machine is switched off without having to press the ON/OFF button in advance, or after switching on the machine, without having activated any button and/or selector (otherwise, the Push & Wash function will be deactivated). To start the Push & Wash cycle press and hold the relative button for 2 seconds. The lit indicator light indicates that the cycle has started. This wash cycle is ideal for cotton or synthetic fabrics, as it washes at a temperature of 30° and a maximum spin speed of 1000 rpm. Load the laundry (cotton and/or synthetic garments) and close the door. Start the programme by pressing and holding the Push & Wash button for 2 seconds. The relative indicator light turns green and the door will lock (the DOOR LOCKED symbol turns on). : starting the wash cycle through the Push & Wash button activates an automatic non-customisable cycle recommended for cotton and synthetic fabrics. This programme does not allow for setting any additional options. To open the door while an automatic cycle is under way, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. Once the programme is finished, the END written turns on. Load (kg) Total water lt 33 75 55 Wash cycles Detergents Fabric softener Wash Description of the wash cycle Residual dampness % Energy consumption kWh 70 0. 68 - 1 2 3 4 5 6 7 8 9 9 10 11 12 13 14 Everyday 30° ECO Daily cotton Daily synthetics Coloureds Delicates Rapid 30min: to refresh lightly soiled garments quickly (not suitable for wool, silk and clothes which require washing by hand). 03 85 195’ * If you select programme and exclude the spin cycle, the machine will drain only. ** The duration of the wash cycle can be checked on the display. [. . . ] €¢ The free end of the hose is under water (see “Installation”). €¢ The wall drainage system is not fitted with a breather pipe. If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the Assistance Service. If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the washing machine to fill with water and drain continuously. [. . . ]