User manual INDESIT CA55NF

[. . . ] Pass them on to possible new owners of the appliance. Electrical connections After the appliance has been transported, carefully place it vertically and wait at least 3 hours before connecting it to the electricity mains. Before inserting the plug into the electrical socket ensure the following: • The appliance is earthed and the plug is compliant with the law. • The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. g. [. . . ] Unscrew the bottom hinge pin and refit it on the opposite side. . Fit the bottom hinge making sure that the door is aligned to the cabinet. Carefully stand the appliance upright in it’s required location and make sure it is sitting level on the floor. Open and close the doors checking that the gasket makes a good seal without any gaps when the doors are closed. 1 2 3 Note: Replace loose items/fittings back into the appliance and leave for at least 15 minutes before switching back on. 4 Description of the appliance Overall view GB TEMPERATURE REGULATING Knob POWER Indicator light FAST FREEZE and LOW AMBIENT switch Removable lidded shelf with EGG TRAY* Removable multipurpose SHELVES• Compartment for a 2 LITRE BOTTLE FRUIT and VEGETABLE bin BOTTLE shelf SHELVES• FREEZER and STORAGE compartment STORAGE compartment Levelling FOOT • Varies by number and/or position. There is only one adjustable foot. * Available only on certain models. 5 Start-up and use GB Starting the appliance !Before starting the appliance, follow the installation instructions (see Installation). Before connecting the appliance, clean the compartments and accessories well with lukewarm water and bicarbonate. Insert the plug into the socket and ensure that the POWER indicator light illuminates. Turn the TEMPERATURE ADJUSTMENT knob to an average value. After a few hours you will be able to put food in the refrigerator. • Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). • Remember that cooked foods do not last longer than raw foods. • Do not store liquids in open containers. So when the fresh food is frozen return the switch to its ". OFF position, " Note: for Energy Saving ensure that "Fast Freeze and Low Ambient" is switched off after 24 hours. For the refrigerator to operate properly the "Fast Freeze and Low Ambient" button must be ON when room temperature is 16°C or lower. GB 7 Maintenance and care GB Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on OFF (appliance off) to eliminate all electrical contact. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb (A) by unscrewing the fixing screw (B) which is located at the back of the lampcover, as shown (see diagram). Replace it with a similar light bulb, the power of which should not exceed 15W. Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia. • The removable accessories may be soaked in warm water and soap or dishwashing liquid. • The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. A B Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Defrosting the refrigerator compartment The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. [. . . ] • The outside ambient temperature is very high. • The thickness of the frost exceeds 2-3 mm (see Maintenance). • The appliance has not been installed on a level surface (see Installation). • The appliance has been installed between cabinets that vibrate and make noise. [. . . ]