User manual INDESIT DP2GS

[. . . ] The electric spark between the ignition plug and the burner provides the ignition of the burner itself. After ignition, immediately release the push-button and adjust the flame according to need. For models with a thermoelectric safety system, the burner is ignited as in the various cases described above, keeping the knob fully pressed on the maximum position for approximately 3/5 seconds. After releasing the knob, make sure the burner is actually lit. [. . . ] : - we recommend the use of pots and pans with a diameter matching that of the burner, thus preventing the flame from escaping from the bottom part and surrounding the pot - do not leave any empty pots or pans on the fire - do not use any tools for grill-cooking on Crystal hobs. When cooking is finished, it is also a good norm to close the main gas pipe tap and/ or cylinder. 1 wok fast auxiliary Ø 20-32 Ø 20-26 Ø 10-14 Prior to any operation, disconnect the appliance from the electrical system. For long-life to the equipment, a general cleaning operation must take place periodically, bearing in mind the following: - the glass, steel and/or enamelled parts must be cleaned with suitable non-abrasive or corrosive products (found on the market). avoid chlorine-base products (bleach , etc. ); - avoid leaving acid or alkaline substances on the working area (vinegar, salt, lemon juice, etc. - the wall baffle and the small covers (mobile parts of the burner) must be washed frequently with boiling water and detergent, taking care to remove every possible encrustation. Dry carefully and check that none of the burner holes is fully or partially clogged; - the stainless steel grids of the working area, after having been heated, take on a bluish tint which does not deteriorate the quality. To bring colour back to its original state, use a slightly abrasive product. The plug or omnipolar switch must be easily reached on the installed equipment. 3) Connect the appliance to the gas cylinder or to the installation according to the prescribed standards in force, and ensure beforehand, that the appliance matches the type of gas available. The type of gas for which the appliance is predisposed is shown on the appliance identification plate. Otherwise, see “Adaptation to various types of gas”. Furthermore, check that the feed pressure falls within the values described on the table: “User chacteristics”. Rigid/semi rigid metal connection Carry out the connection with fittings and metal pipes (even flexible pipes) so as to obtain counter stress the inner parts of the appliance. - when the installation has been carried out, check the perfect sealing of the entire connection system, by using a soapy solution. 4 12 To avoid all risk, if the power cable becomes damaged, it must only be replaced by the manufacturer, by an authorised service centre, or by a qualified electrician. Wok C3 only GB Should the appliance be pre-set for a different type of gas than that available, proceed as follows: • replace the injectors (Fig. [. . . ] Wok C3 only GB Should the appliance be pre-set for a different type of gas than that available, proceed as follows: • replace the injectors (Fig. 5) with the corresponding type of gas to be used (see table “Uses characteristics”). € to adjust to the minimum, use a screwdriver on the screw placed on the tap (Fig. 6) after turning the tap to its minimum position. [. . . ]