User manual INDESIT EWE 61252 W EU

[. . . ] Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Running a wash cycle, 8 Detergent dispenser drawer Preparing the laundry Fast daily cycles Special wash cycles Load balancing system This instruction manual should be kept in a safe GB place for future reference. if the washing machine Is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/ herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. Remove the washing machine from its packaging. [. . . ] TEMPERATURE button : press to decrease or completely exclude the temperature: the value will be shown on the display. DELAYED START button : press to set a delayed start time for the selected wash cycle. The delay time will be shown on the display. START/PAUSE button with indicator light: when the green indicator light flashes slowly, press the button to start a wash cycle. Once the cycle has begun the indicator light will remain lit in a fixed manner. To pause the wash cycle, press the button again; the indicator light will flash in an orange colour. If the symbol is not illuminated, the door may be opened (wait approximately 3 minutes). To start the wash cycle from the point at which it was interrupted, press the button again. Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again. The display is useful when programming the machine and provides a great deal of information. The duration of the available programmes and the remaining time of a running cycle appear in section A; if the DELAY START option has been set, the countdown to the start of the selected programme will appear. Pressing the relative button, the machine automatically displays the maximum temperature and spin speed values set for the selected cycle, or the most recently-used settings if they are compatible with the selected cycle. The "programme phases" relative to the selected programme and the "programme phase" of the running programme appear The icons corresponding to "temperature" , "Programmed start" and "spin" If the symbol lights up, the display will visualise the set "temperature" value. When a "delayed start" has been set, the symbol lights up. If the symbol lights up, the display will visualise the set "spin" value. Door locked symbol The lit symbol indicates that the door is locked. To prevent any damage, wait until the symbol turns off before opening the door. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened (wait approximately 3 minutes). To change a wash cycle while it is in progress, pause the washing machine using the START/PAUSE button (the START/PAUSE indicator light will flash slowly in an orange colour); then select the desired cycle and press the START/PAUSE button again. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened (wait approximately 3 minutes). Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. [. . . ] The washing machine does not take in water ("H2O" will flash on the display). The water inlet hose is not connected to the tap. The START/PAUSE button has not been pressed. The washing machine continuously takes in and drains water. [. . . ]