User manual INDESIT FV1 GB

[. . . ] Water container empty the water container after each drying cycle. Step 1 Pull the water container towards you and remove it completely from the dryer. Step 2 Empty all the water in the water container. Step 2 Pull out the filter (using two fingers). Step 3 Replace the water container making sure that it is securely fixed. Step 3 Clean off any fluff build-up on the internal surface of the filter. Failure to empty the water container may cause the following: - The dryer stops heating (thus the load may still be damp at the end of the drying cycle). - The Empty water container LED activates to show that the water container is full. Filling of the Water Container Step 4 Replace the filter never operate the dryer without the filter in place. When the dryer is first used water will not immediately enter the water container as the pump needs to be primed. This is done automatically and will take a few minutes, during this period the efficiency of the drying process is not affected. 2 Condenser unit - remove any fluff build-up from the condenser on a monthly basis. Step 1 Open the condenser cover - grip the handle and pull towards you. EN Step 2 Remove the condenser by turning the 3 catches, then pull the condenser towards you. [. . . ] When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume the Delay start programme. The Delay start indicator light flashes and the display visualises the time remaining to the start of the selected programme. It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running phase and the START/PAUSE indicator light stops flashing and turns green. During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from the beginning. By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This procedure can be used to select the Cold drying programme to cool garments if they are judged to be dry enough. Press the START/PAUSE button to start the new programme. Note: In the event of a power cut, turn the power switch off and remove the plug; when the electricity supply returns, press the START/PAUSE button to resume the programme. 10 Laundry Sorting laundry Check the symbols on the care labels of the various garments to verify whether the garments can be safely tumble dried. We suggest removing these items and replacing them in the dryer once they have been shaken out: repeat this procedure several times during the course of the drying cycle. All fabrics contain natural dampness which helps to keep them soft and fluffy. The drying times provided refer to the automatic Cupboard dry programmes. The Timed drying settings are also indicated to enable you to select the most suitable timed option. The weight refers to dry items. Drying times Drying times are approximate and may vary depending on the following: Amount of water retained by items after the spin cycle: towels and delicate items retain a lot of water. Fabrics: items of the same fabric, but with different texture and thickness may have different drying times. Amount of laundry: single items and small loads may take longer to dry. Drying: if items are to be ironed, they can be removed from the dryer while still slightly damp. Items that require complete drying can be left longer. Automatic drying times Cotton High heat Drying tim es after 800-1000 rpm wash cycles Half load 2 kg 3 kg 4 kg 5 kg 6 kg 0:40-0:55 0:55-1:10 1:10-1:20 1:20-1:30 1:35-2:00 1:00 or 1:30 1:00 or 1:30 1:30 or 2:00 1:30 or 2:00 2:20 or 2:40 Full load 7. 5 kg 2:00-2:40 2:20 or 3:00 Autom atic (hrs:m ins) Tim ed (hrs:m ins) S ynthetics Low heat 1 kg 0:30-0:40 0:30 or 1:00 7 kg 2:20-2:30 2:20 or 2:40 Autom atic (hrs:m ins) Tim ed (hrs:m ins) Acrylics Low heat Drying tim es after wash cycles at lower speeds Half load 1 kg 2 kg 0:40 - 0:50 0:50 - 1:10 0:30 or 1:00 0:30 or 1:00 Full load 3 kg 1:10 - 1:30 1:00 or 1:30 Autom atic (hrs:m ins) Tim ed (hrs:m ins) Drying tim es after wash cycles at lower speeds Half load 1 kg 0:40 - 1:00 0:30 or 1:00 or 1:30 Full load 2 kg 0:55 - 1:15 1:00 or 1:30 or 2:00 12 Warnings and suggestions !This appliance was designed and manufactured in compliance with current international safety standards. The following information is provided for safety reasons and must be read carefully. Do not tumble dry large, excessively bulky items. [. . . ] Provide the following data when contacting the Technical Assistance Centre: name, address and postal code telephone number type of malfunction date of purchase the appliance model (Mod. ) the dryers serial number (S/N) This information can be found on the data plate located behind the door. Comparative programmes recommended programmes for the EN61121 comparative test. Programme (EN61121) Cotton drying cycle Cotton drying ironing Easy care fabric Programme to be selected Cotton Cupboard dry Cotton Iron dry Synthetic Cupboard dry Load size 7. 5 kg 7. 5 kg 3 kg !Note: this is not a complete list of the programme options. This appliance conforms to the following EEC directives: - 2006/95/EC (Low Voltage Directive) - 89/336/EEC, 92/31/EEC, 93/68/EEC (Electromagnetic Compatibility Directive). 16 Guarantee 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturers guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is subject to the following conditions: The appliance has been installed and operated correctly and in accordance with our operating and maintenance instructions. [. . . ]