User manual INDESIT H 661

[. . . ] Pass them on to possible new owners of the appliance. Your appliance is supplied with a 13amp fused plug that can be plugged into a 13amp socket for immediate use. Before using the appliance please read the instructions below. WARNING: THIS APPLIANCE MUST BE EARTHED. Replacing fuse covers: When replacing a faulty fuse, a 13amp ASTA approved fuse to BS 1362 should always be used and the fuse cover re-fitted. [. . . ] Insert the plug into the socket and ensure that the internal light illuminates ( the FREEZER OPERATION knob must not be on the position) . Turn the FREEZER OPERATION knob and REFRIGERATOR OPERATION knob to an average value. After a few hours you will be able to put food in the refrigerator. Using the refrigerator to its full potential Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). Remember that cooked foods do not last longer than raw foods. Do not store liquids in open containers. They will increase humidity in the refrigerator and cause condensation to form. GB 1 2 SHELVES: with or without grill. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Height can be adjusted without complete removal of the shelf. Setting the temperature The temperature inside the refrigerator compartment automatically adjusts itself according to the position of the thermostat knob. min= warmest max = coldest We recommend, however, a medium position. Chiller system It is recognisable by aeration cells located on the back walls of the compartments. The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. The system maintains an optimal humidity level in the compartment, preserving the original quality of the food, preventing the food from sticking together and making defrosting a thing of the past. Replace it with a similar light bulb within the power range indicated on the cover (10W). GB Cleaning the appliance The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia. The removable accessories may be soaked in warm water and soap or dishwashing liquid. The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. 7 Precautions and tips GB !The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. This appliance complies with the following Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03. 05. 89 (Electromagnetic Compatibility) and subsequent amendments; - 2002/96/CE. Disposal Observe local environmental standards when disposing packaging material for recycling purposes. The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. [. . . ] The appliance makes a lot of noise. The TEMPERATURE ADJUSTMENT knob is not in the correct position. The door is not closed properly or is continuously opened. The outside ambient temperature is very high. The appliance has not been installed on a level surface (see Installation). [. . . ]