User manual INDESIT IDCEHG45B

[. . . ] Conservez cette notice toujours à côté du sèche-linge et si vous vendez cet appareil ou que vous le donniez à un tiers, faites en sorte que cette notice accompagne le sèche-linge de manière à ce que le nouveau propriétaire soit informé des avertissements et des conseils concernant le fonctionnement de ce sèche-linge. Tournez le bouton Programmes jusqu’à positionner l’indicateur sur le programme correspondant au type de linge à sécher, en contrôlant le tableau des programmes (voir Programmes et options) et les indications pour chaque type de tissu (voir Linge). 16 Instruction manual TUMBLE DRYER Contents Important information, 18-19 EN English EN Installation, 20 Where to install the tumble dryer Ventilation Electrical connections Preliminary information Description of the tumble dryer, 21-22 Features Control panel How to carry out a drying cycle, 23 Starting and selecting a programme Programmes and options, 24-25-26 Programme chart Special programmes Options Opening the door Sorting laundry Care labels Special garments Drying times IDCE H G45 B Laundry, 27-28 Warnings and suggestions, 29 Care and maintenance, 30 General safety Saving energy and respecting the environment Disconnecting the power supply Cleaning the filter after each cycle Checking the drum after each cycle Emptying the water container after each cycle Cleaning the condenser unit Cleaning the tumble dryer !This symbol reminds you to read this instruction manual. [. . . ] € To recall the option will simply turn on the dryer, press button Memo and start. It is possible to change the option as for each cycle, less than incompatibility. At intervals of 2 minutes will appear on the display the number of the cycle recalled. If it is not stored any cycle, an alarm and an indicator will signal the absence. € To record a new program just repeat storage. Alarm A buzzer sounds at the end of the drying cycle to signal that the programme has ended and the garments are ready to be removed. Not all options are available on all programmes (see Programmes and options). Opening the door If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may occur: • The START/PAUSE button flashes orange. € When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume the “Delay start” programme. The “Delay start” indicator light flashes and the display visualises the time remaining to the start of the selected programme. € It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running phase and the START/PAUSE indicator light stops flashing and turns green. € During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from the beginning. € By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This procedure can be used to select the COOL drying programme to cool garments if they are judged to be dry enough. Press the START/PAUSE button to start the new programme. Note: If you have a power cut, switch off the power or remove the plug. When power is restored, plug in the machine, press and hold the ON/OFF button until the dryer reactivates, then press Start/Pause button. 26 Laundry Sorting laundry • Check the symbols on the care labels of the various garments to verify whether the garments can be safely tumble dried. € Sort laundry according to the type of fabric. [. . . ] € The remaining time is constantly monitored during the drying cycle and is updated to show the best forecast. It is normal for the displayed time to increase during the cycle. € This is normal, especially if the dryer has not been used for a long time. If the noise persists during the entire cycle, contact the Technical Assistance Centre. [. . . ]