User manual INDESIT IDL 40

[. . . ] NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications. After removing the packing, check to make sure that the appliance is not damaged. The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. [. . . ] Turn on the water tap completely and press ON-OFF button "A". You will hear a short beep and indicator light "B" lights up. Turn the cycle selector knob "D" clockwise until the reference notch on the knob corresponds with the number or symbol for the cycle you wish to set (consult the wash cycle table on page 17, especially when first using the appliance). If the appliance door is shut, press the Start button "R" and you will hear a beep; the cycle will start up within a few seconds. Cycle phase indicator lights The dishwasher is provided with 4 indicator lights "G" which come on in sequence as the appliance is performing that specific phase of the wash cycle. These phases are: If you have left out a dish. You can interrupt a wash cycle by pressing the ON-OFF button, then place the dishes you had left out into the appliance, which will start up from where it was interrupted when you turn it back on. The wash cycle stops and then restarts when the electricity comes back on or when the door is shut. The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light. Wait a few minutes before unloading the dishes: if you wait a little while, they dry better thanks to the steam. ⷠEmpty the lower rack first. Warning: when you open the dishwasher door after the wash cycle has just ended or is under way, take care not to scald yourself with the hot steam. Premise: You can cancel the wash cycle in progress, if it has only just started. To modify a wash cycle, keep the RESET button "R" pressed for about 5 seconds: a prolonged beep will sound, followed by three short beeps. Indicator light "G" will turn off and at this point, all the settings will have been cancelled. To select a new wash cycle, repeat the operations illustrated in the paragraph entitled "starting and selecting the cycle". Warning: the knob must be turned clockwise from wash cycle 1 to 4, an anti-clockwise from wash cycle 4 to 1. Cold rinse Rinse with hot water at 70°C. Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. Economic and fast cycle to be used for slightly dirty dishes. Preliminary wash cycle for dishes and pans awaiting completion of the load with the dishes from the next meal. Short cold wash to prevent food from drying onto the dishes. [. . . ] If the alarm persists, first turn off the water tap to avoid any flooding and then cut off the electricity supply and call for technical assistance. If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact the nearest authorised service centre and provide them with the following information: - the nature of the problem; - the model type number (Mod. Never call on unauthorised technicians and refuse to allow parts to be installed that are not original spare parts. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. [. . . ]