User manual INDESIT IDL700DOT2

[. . . ] The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. Fundamental rules to follow when using the appliance: - Never touch the dishwasher when barefoot or with wet hands or feet; - We discourage the use of extension cords and multiple sockets; - During installation, the power supply cord must not be excessively or dangerously bent or flattened; - If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. [. . . ] F 4 5 GB Turning on the Appliance How to start a wash cycle… After performing all the operations described in the previous paragraphs, turn the water tap on completely and press ONOFF button "A": you will hear a short beep and indicator light "B" lights up. At this point, the appliance is on and ready to be programmed Starting and selecting the cycle. If the appliance door is shut, press the Start button "R" and you will hear a beep; the cycle will start up within a few seconds. Cycle phase indicator lights The dishwasher is provided with 4 indicator lights "G" which come on in sequence as the appliance is performing that specific phase of the wash cycle. These phases are: • Turn off the water tap. €¢ Wait a few minutes before unloading the dishes: if you wait a little while, they dry better thanks to the steam. • Empty the lower rack first. Warning: when you open the dishwasher door after the wash cycle has just ended or is under way, take care not to scald yourself with the hot steam. When you have loaded the dishes, you can choose when to start your dishwasher before setting the wash cycle desired. Press button "H" to delay the start of the wash cycle by 12, 9, 6 or 3 hours. Each time you press it, you will hear a short beep and the indicator light "G" corresponding to the selected delay will light up. &\FOH &\FOH VHOHFWLRQ LQVWUXFWLRQV &\FOH GHVFULSWLRQ 'HWHUJHQW 5LQVH IRU SUH $LG ZDVK  ZDVK :DVK F\FOH GXUDWLRQ WROHUDQFH “   , QWHQVLYH Pre-wash with hot water at 40°C Very dirty dishes and pans Wash at 65°C. (not to be used for 2 cold rinses delicate items). Cold rinse Rinse with hot water at 70°C.   (FR Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. 2 Cold pre-washes Wash at 50°C Hot rinse at 65°C Drying    J   5DSLG  Economic and fast cycle to be used for slightly dirty Short wash at 50°C. Run cycle Rinse with hot water at 62°C. Preliminary wash cycle for dishes and pans awaiting Short cold wash to prevent food completion of the load from drying onto the dishes.  JU   6RDN   &U\VWDO Wash at 52°C Rinse at 45°C Hot rinse at 65°C Drying  J   -XVW < RX Special, economic and fast cycle for a fairly small Wash at 50°C daily load of dishes. This Hot rinse at 67°C may only be done on the upper rack.  J  7 GB Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle. [. . . ] If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance. Hot Water Connection The water supply to the appliance can also be connected to the house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60° C. In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line. [. . . ]