User manual INDESIT IDL730DOT2

[. . . ] The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. Fundamental rules to follow when using the appliance: - Never touch the dishwasher when barefoot or with wet hands or feet; - We discourage the use of extension cords and multiple sockets; - During installation, the power supply cord must not be excessively or dangerously bent or flattened; - If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. [. . . ] How to adjust the upper rack …. To do so, open the rail stop flaps and pull the rack out completely; now place it with the back wheels in high or low position, then slide it along the guide rails until the front wheels also go in; now close the rail stop flaps (see fig. F 4 5 GB Turning on the Appliance How to start a wash cycle… After performing all the operations described in the previous paragraphs, turn the water tap on completely and press ONOFF button "A": you will hear a short beep and indicator light "B" lights up. At this point, the appliance is on and ready to be programmed Starting and selecting the cycle. If the appliance door is shut, press the Start button "R" and you will hear a beep; the cycle will start up within a few seconds. Cycle phase indicator lights The dishwasher is provided with 4 indicator lights "G" which come on in sequence as the appliance is performing that specific phase of the wash cycle. These phases are: At the end of the wash cycle…. The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light. Warning: Turn the appliance off by pressing button “A”, unplug the appliance from the electricity socket to cut off the power supply; the power supply cable should consequently be easily accessible. • Turn off the water tap. €¢ Wait a few minutes before unloading the dishes: if you wait a little while, they dry better thanks to the steam. --------:DVK F\FOH GXUDWLRQ WROHUDQFH “  &\FOH &\FOH GHVFULSWLRQ  , QWHQVLYH Pre-wash with hot water at 40°C Very dirty dishes and pans Wash at 65°C. (not to be used for 2 cold rinses delicate items). Cold rinse Rinse with hot water at 70°C.   (FR Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes.   5DSLG  Economic and fast cycle to be used for slightly dirty Short wash at 47°C. Run cycle Rinse with hot water at 62°C. Preliminary wash cycle for dishes and pans awaiting Short cold wash to prevent food completion of the load from drying onto the dishes.   -XVW < RX Special, economic and fast cycle for a fairly small Wash at 50°C daily load of dishes. This Hot rinse at 67°C may only be done on the upper rack.  Tablets 1 7 GB Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle. [. . . ] Hot Water Connection The water supply to the appliance can also be connected to the house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60° C. In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line. Anti-flooding protection Your dishwasher is provided with a special system which blocks the water supply in the event of leaks inside the appliance. [. . . ]