User manual INDESIT IDVL 75 B FR

[. . . ] Instruction manual TUMBLE DRYER EN English Contents Installation, 2 Where to install the tumble dryer Ventilation Electrical connections Levelling the tumble dryer Before you start your dryer GB Warnings, 4 General safety Saving energy and respecting the environment Care and maintenance, 6 Disconnecting the power supply Cleaning the filter after each cycle Checking the drum after each cycle Cleaning the tumble dryer Features Control panel Description of the tumble dryer, 7 IDVL 75B R How to carry out a drying cycle, 9 Starting and selecting a programme Programmes and options, 10 Programme chart Special programmes Options Opening the door Laundry, 13 www. indesit. co. uk ! This symbol reminds you to read this instruction manual. Keep this manual at hand for immediate reference whenever necessary. Always store this manual close to the tumble dryer and remember to pass it on to any new owners when selling or transferring the appliance, so they may familiarise with the warnings and suggestions herein contained. Sorting laundry Care labels Drying times Troubleshooting, 14 Assistance and Guarantee, 15 Spare parts Information on recycling and disposal !Read these instructions carefully: the following pages contain important information on installation and useful suggestions for operating the appliance. 1 Installation GB Where to install the tumble dryer Install the dryer far from gas ranges, stoves, radiators or hobs, as flames may damage it. [. . . ] Open the door, ensure that the filter is clean and securely placed (see Care and maintenance). Load the machine, making sure that no piece of laundry gets between the door and the relative seal. After consulting the programme chart and the indications for each type of fabric (see Laundry), turn the Programme selection knob towards the programme corresponding to the type of laundry to be dried (see Programmes and options). Warning: If the position of the programme selection knob changes after pressing the START/PAUSE button, the selected programme will NOT be modified. To modify the programme, press the START/PAUSE button to put the programme in pause mode (the indicator light flashes orange), then select a new programme and the relative options. Press the START/PAUSE button to start the new programme. If necessary, set the time of the delayed start and any other options (see Programmes and options). Press the START/PAUSE button to start the drying cycle. Laundry can be checked while the drying programme runs and any garments already dry can be removed, while drying continues for the remaining items. After closing the door, press the START/PAUSE button to resume machine operation. the fabrics are cooled) activates during the last few minutes of the drying programme; always allow this phase to terminate. When the END indicator light turns on, the programme has ended. The buzzer will beep 3 times to let you know that your programme is complete. Open the door, remove the laundry then clean the filter and replace it. If the clothes are not removed at the end of the cycle the automatic POST CREASE CARE action will, on those programmes with this feature, continue to rotate the drum intermittently for up to 10 hours to minimise creasing. The phase is stopped when the door is opened or when the knob is set to OFF 10. Set the program knob to OFF to switch off the machine. Disconnect the dryer from the power supply. Automatic pre-post Anti Crease This is an automatic function which provides an anti crease treatment both before and after the drying programme. By periodically rotating the drum before the start of the drying cycle, when a delayed start is selected, the formation of creases is prevented. On certain programmes the drum also rotates periodically at the end of the drying cycle on. The phase is stopped when the door is opened or when the knob is set to OFF Stand-by mode This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. [. . . ] If an automatic programme has not detected the final dampness level required in this interval, the dryer completes the programme and stops. Check the above points and repeat the programme; if the items are still damp, contact the Technical Assistance Centre (see Assistance). The dryer is noisy during the first few minutes of operation. The lights on the dryer control panel are off although the dryer is switched on. • This is normal, especially if the dryer has not been used for a long time. If the noise persists during the entire cycle, contact the Technical Assistance Centre. [. . . ]