User manual INDESIT IHVP 6.6 LM K

[. . . ] The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. Never use the hood without effectively mounted grids. The hood must NEVER be used as a support surface unless specifically indicated. [. . . ] Information about the conversion of the hood from suction version to filtering version is present in this manual. Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. The exhausting pipe is not supplied and must be purchased apart. Diameter of the exhausting pipe must be equal to that of the connection ring. If the hood is supplied with active charcoal filter, then it must be removed. Filter version The aspirated air will be degreased and deodorised before being fed back into the room. In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal. The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Note: The intensive extraction speed (power) is timed and lasts for 5 minutes (indicator c flashes); the hood then reverts to extraction speed (power) 2. ON/OFF Timer button: delays the deactivation of the selected extraction speed (power) by 5 minutes. Note: the button is also used for the "Filter saturation signal reset" function 4. Extraction speed (power): the indicator rotates according to the selected extraction speed (power). Safety operation: the indicator flashes. Grease filter saturation: comes on when filter maintenance is required. Active carbon filter saturation: comes on when filter maintenance is required. Note: this function is normally disabled and should only be activated if the hood is used as a filter version (with carbon filter fitted). To do so, proceed as follows: - switch off the hood - press and hold buttons 1 and 3 at the same time, until the indicator stops flashing (indicator disabled) and is lit steadily (indicator enabled). To deactivate it, repeat the procedure: the indicator will no longer be lit steadily (indicator enabled) and will flash instead (indicator disabled). Safety operation The hood has a sensor which, in the event of a sudden increase in temperature, activates the appliance until the temperature drops significantly. Filter saturation signal reset After carrying out filter maintenance, press and hold button 3 until indicator. Cleaning Clean using ONLY the cloth dampened with neutral liquid detergent. Clean the perimeter aspiration panel with the same frequency as the ant-fats filter, using a cloth and not too concentrated liquid detergent. [. . . ] - the omnipolar disconnection device has not tripped. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Please check the plate in order to verify the total absorption and the light absorption. [. . . ]