User manual INDESIT IP 641 S (IX)

[. . . ] Practical advice on using the burners Switching the appliance off Cleaning the appliance Gas tap maintenance Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. Checking the tightness of the connection When the installation process is complete, check the pipe fittings for leaks using a soapy solution. To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Remove the hob grids and slide the burners off their seats. Unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 Burner and nozzle characteristics). In the case of the Mini WOK burner, use a spanner with a 7 mm opening to unscrew the nozzle (see figure). Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Sticker are available from any of our Service Centres. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. Some appliances have a safety device (thermocouple) If the device fails to work when the burners are Set to the low flame setting, increase this low flame Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Stickers are available from any of our Service Centres. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). This appliance conforms to the following European Economic Community directives: -2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments - 89/336/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments. (1) Only for appliances with the security device. Support Grid for COOKWARE Support Grid for COOKWARE Use the diameter of the cookware to choose the most appropriate burner to cook with. Control Knobs for GAS BURNERS adjust the size of the flame. gAS BURNER ignition* enables a specific burner to be lit automatically. [. . . ] After cleaning, rinse and dry any remaining drops of water. The position of the central grid may be inverted. If this happens, the spokes will appear particularly misaligned and the intersection point will no longer be at the centre of the burner. There is a hole on the grids at the side; this should be aligned with the fixing point of the tab or hinge (if the glass cover is fitted) located on the rear part of the hob (see figure). [. . . ]