User manual INDESIT IPG751SGB

[. . . ] That the inlet and draining pipes are connected correctly. Never use hoses that have already been used, always use the new ones provided with your machine; 3. That the washing machine is levelled properly; something worth checking to aid the performance of your washing machine; 4. That the drum's fixing screws have been removed from the back of the washing machine; 2. [. . . ] For safety reasons, if the washing machine does not load water, it cannot start a wash cycle. select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is showing an anomaly. But where did all the water go? Simple: with the new Indesit technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. And, on top of that, you are also saving electricity. The washing machine fails to fill with water. RIGHT Turn off the water supply after use. This will eliminate the possibility of leakage. Always leave the appliance door ajar to avoid bad odours. Clean the appliance's exteriors gently. To clean the exteriors and the rubber parts of the appliance, always use a soft cloth dipped in warm and soapy water. WRONG Leave the washing machine plugged in while cleaning. Even during maintenance, the appliance should always be unplugged. Never use solvents or abrasives to clean the external and rubber parts of the washing machine. This function requires manual selection for draining. To check it, turn off the water supply, unplug the washing machine and follow the instructions on page 12, or call for technical assistance. Too much foam. Is the detergent appropriate for machine washing?Check whether the definition on its label reads "for machine wash" or "hand and machine wash", or any other similar wording. An excessive amount of detergent, besides producing too much foam, does not guarantee a more effective wash, and causes scaling in the internal parts of the appliance. If, despite all checks, the washing machine fails to function and the problem persists, call your nearest authorised Customer Service Centre, providing the following information: - the nature of malfunction - the model type no. . . . . ) - the serial number (S/N . . . . ) This information can be found on the data plate situated at the back of the washing machine. The washing machine leaks. Is the metal ring of the inlet hose properly attached?Turn off the water supply, unplug the appliance and try tightening its attachment without forcing it. Turn off the water supply, unplug the appliance and try tightening its attachment. Excessive vibration during the spin cycle. Have all transit screws been removed durind installation?See the following page on installation procedures. Has the washing machine been levelled correctly?The levelling of the appliance should be checked periodically. [. . . ] The power supply cable must never be bent or dangerously compressed. I only want an authorised specialised technician with original Indesit spare parts! Your washer has been built in compliance with the strictest international safety regulations. Never pull on the supply cable or the washing machine to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high temperatures. The appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. [. . . ]