User manual INDESIT IS60G1

[. . . ] Operating Instructions COOKER GB GB English, 1 Contents Installation, 2-6 Positioning and levelling Electrical connection Gas connection Adapting to different types of gas Technical data Table of burner and nozzle specifications Description of the appliance, 7 Overall view Control panel Start-up and use, 8-10 IS60G1 Using the hob Using the oven Oven cooking advice table Precautions and tips, 11 General safety Disposal Respecting and conserving the environment Care and maintenance, 12 Switching the appliance off Cleaning the appliance Replacing the oven light bulb Gas tap maintenance Assistance You must read these instructions prior to using your appliance and retain them for future use. Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance. Please keep these operating instructions for future reference. [. . . ] unscrew the burner fastening screws 4. remove screw “V” and then V the oven burner; 2. EC Directives 2006/95/EC dated 12/12/06 (Low Voltage) and subsequent amendments 04/108/EC dated 15/12/04 (Electromagnetic Compatibility) and subsequent amendments 2009/142/EC dated 30/11/09 (Gas) and subsequent amendments 90/68/EEC dated 22/07/93 and subsequent amendments. 1275/2008(Stand-by/Off-mode) IS60G1 Useful measurements relating to the oven compartment Voltage and frequency Burners 6 Description of the appliance Overall view GB Gas burner Hob grid Control panel Containment surface for spills GUIDE RAILS for the sliding racks position 5 position 4 position 3 position 2 position 1 Adjustable foot GRILL rack DRIPPING PAN Adjustable foot Control panel Button for Oven Light Electronic Lighting for Hob Burners Oven and Grill Control Knob Timer Knob Control Knobs for Gas Burners on Hob 7 Start-up and use Using the hob Practical advice on using the burners Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting E. Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. This may be the minimum setting C, the maximum setting E or any position in between the two. If the appliance is fitted with an electronic lighting device* (see figure), press the ignition button, marked with the symbol knob down and turn it in an anticlockwise direction, towards the maximum flame setting, until the burner is lit. The burner may be extinguished when the knob is released. If this occurs, repeat the operation, holding the knob down for a longer period of time. If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight it. If the appliance is equipped with a flame failure safety device*, press and hold the BURNER knob for approximately 3-7 seconds to keep the flame alight and to activate the device. To switch the burner off, turn the knob until it reaches the stop position •. For the burners to work in the most efficient way possible and to save on the amount of gas consumed, it is recommended that only pans that have a lid and a flat base are used. They should also be suited to the size of the burner. Burner Fast (R) Semi Fast (S) Auxiliary (A) ø Cookware diameter (cm) 24 - 26 16 - 20 10 - 14 GB To identify the type of burner, please refer to the diagrams contained in the “Burner and nozzle specifications”. On the models supplied with a reducer shelf, remember that this should be used only for the auxiliary burner when you use casserole dishes with a diameter under 12 cm. 1, then hold the BURNER Using the oven !The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may emit a slightly unpleasant odour caused by protective substances used during the manufacturing process burning away. Before operating the product, remove all plastic film from the sides of the appliance. Never put objects directly on the bottom of the oven; this will avoid the enamel coating being damaged. [. . . ] • Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. 11 Care and maintenance 06/2011- 195089012. 01 XEROX FABRIANO GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced. Cleaning the appliance !Never use steam cleaners or pressure cleaners on the appliance. [. . . ]