User manual INDESIT IS70C

[. . . ] Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer. Remove the 3 protective screws and the rubber bush with the respective spacer, situated on the rear of the appliance (see also the installation leaflet). NB:The plastic spacers may fall down inside the machine once the bolt has been removed, and will not interfere with the operation of the machine. [. . . ] Press button and the maximum temperature allowed for the programme set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, after approximately 2 seconds the setting is accepted: the symbol remains fixed. The temperature adjustment is enabled with all wash programmes. Setting the Delay Timer Programmes Setting the temperature Detergents Functions To enable a function: 1. press the button corresponding to the desired function, according to the table below; 2. the function is enabled when the corresponding button is illuminated. Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. Function Effect Bleaching cycle designed to remove the toughest stains. This option reduces the amount of creasing on fabrics, making them easier to iron. Comments Please remember to pour the bleach into extra compartment 4 (see page 10). This function is incompatible with the EASY IRON function. Enabled with programmes: Precautions Care Stain removal 2, 3, 4, 5, Rinse cycle. Troubleshooting Recommended when the appliance has a full load or with large quantities of detergent. The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. GB Installation General safety This appliance has been designed for nonprofessional, household use and its functions must not be changed. This washing machine should only be used by adults and in accordance with the instructions provided in this manual. Never touch the washing machine when barefoot or with wet or damp hands or feet. Do not pull on the power supply cable to unplug the appliance from the electricity socket. Do not open the detergent dispenser while the appliance is in operation. Do not touch the drain water as it could reach very high temperatures. Never force the washing machine door: this could damage the safety lock mechanism designed to prevent any accidental openings. In the event of a malfunction, do not under any circumstances touch internal parts in order to attempt repairs. Always keep children well away from the appliance while in operation. The appliance door tends to get quite hot during the wash cycle. [. . . ] The detergent dispenser is obstructed (to clean it, see page 12). The drain hose is not secured properly (see page 3). The detergent is not suitable for machine washing (it should bear the definition "for washing machines" or "hand and machine wash", or the like). You used too much detergent. Detergents Precautions The washing machine vibrates too much during the spin cycle. Care The machine is locked and the display flashes, indicating an error code (e. g. [. . . ]