User manual INDESIT IWDD7123

[. . . ] If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the Washer-dryer. Connecting the electricity and water supplies Connecting the water inlet hose Unpacking and levelling Unpacking 1. Remove the Washer-dryer from its packaging. Make sure that the Washer-dryer has not been damaged during the transportation process. [. . . ] Hanger dry: ideal for clothes which do not need to be dried fully; "A2" appears on the display. Cupboard dry: suitable for laundry which can be put back in a cupboard without being ironed; "A3" appears on the display. Extra dry: suitable for garments which need to be dried completely, such as sponges and bathrobes; "A4" appears on the display. B - Based on a set time period: between 30 and 180 minutes. 6 If your laundry load to be washed and dried is much greater than the maximum stated load (see adjacent table), perform the wash cycle, and when the cycle is complete, divide the garments into groups and put some of them back in the drum. At this point, follow the instructions provided for a "Drying only" cycle. Repeat this procedure for the remainder of the load. B: a cooling-down period is always added to the end of each drying cycle. Drying only Use the cycle selector knob to select a drying cycle (11-12) in accordance with the type of fabric. The desired drying level or time may also be set using the DRYING button . • Press the button to enable the option; the indicator light corresponding to the button will switch on. We recommend using a liquid detergent and dosage suitable for a half-load. Sport Shoes (wash cycle 10): is for washing sports shoes; for best results, do not wash more than 2 pairs simultaneously. Express Wash & Dry (wash cycle 13) was designed to wash and dry lightly soiled garments quickly. This cycle may be used to wash and dry a laundry load of up to 0. Compartment 1: Pre-wash detergent (powder) compartment 2: Detergent for the wash cycle (powder or liquid) Liquid detergent should only be poured in immediately prior to the start of the wash cycle. compartment 3: Additives (fabric softeners , etc. ) The fabric softener should not overflow the grid. Load balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly greater than the washing rotation speed. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the Washer-dryer performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. [. . . ] gB Problem: The Washer-dryer does not switch on. Possible causes / Solutions: • The appliance is not plugged into the socket fully, or is not making contact. • • • • • • • • • • The Washer-dryer door is not closed properly. The START/PAUSE button has not been pressed. [. . . ]