User manual INDESIT IWUC 41051C

[. . . ] Instructions for use WASHING MACHINE Contents GB English, 1 GB CZ Česky, 13 FR Français, 25 Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data BG Български, 37 IT Italiano, 49 UK Українська, 61 Care and maintenance, 4 Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 5 General safety Disposal Description of the washing machine and starting a wash cycle, 6-7 IWUC 41051 Control panel Indicator lights Starting a wash cycle Wash cycles, 8 Table of wash cycles Personalisation, 9 Setting the temperature Setting the spin speed Functions Detergents and laundry, 10 Detergent dispenser drawer Preparing the laundry Garments requiring special care Load balancing system Troubleshooting, 11 Service, 12 1 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/ herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] To pause the wash cycle in progress, press this button; the corresponding indicator light will flash orange, while the indicator light for the current wash cycle phase will remain lit in a fixed manner. If the DOOR LOCKED indicator light is switched off, the door may be opened. To start the wash cycle from the point at which it was interrupted, press this button again. Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again. consumption in off-mode: 0 , 5 W Consumption in Left-on: 0 , 5 W 6 Indicator lights The indicator lights provide important information. At the end of the wash cycle the indicator light will switch on. The door can be opened once the DOOR LOCKED indicator light turns off. Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washing machine off by pressing the ON/OFF button. 7 Wash cycles GB Table of wash cycles Residual dampness % Max. Load (kg) Description of the wash cycle Max. Speed (rpm) Cycle duration 140’ 140’ 95’ 85’ 85’ 160’ 105’ 20’ 50’ 55’ 70’ 80’ 55’ 50’ 36’ 16’ Detergents Prewash Wash Fabric softener Total water lt 44 44 26 27 32 Wash cycles Energy consumption kWh 1, 46 0, 77 0, 66 0, 67 0, 42 0, 65 - Daily 1 Cotton with prewash: extremely soiled whites. 11 Jeans Sport 12 Sport Intensive 13 Sport Light 14 Sport Shoes Partial wash cycles Rinse Spin + Drain 20° 20° 20° 30° 40° 40° 30° 30° 30° - 4 4 - The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. 1) Test wash cycle in compliance with directive 1061/2010: set wash cycle 2 with a temperature of 60°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 60°C. The actual washing temperature may differ from the indicated value. 2) Test wash cycle in compliance with directive 1061/2010: set wash cycle 3 with a temperature of 40°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 40°C. The actual washing temperature may differ from the indicated value. For all Test Institutes: 2) Long wash cycle for cottons: set wash cycle 3 with a temperature of 40°C. [. . . ] gB Problem: The washing machine does not switch on. Possible causes / Solutions: • The appliance is not plugged into the socket fully, or is not making contact. € The water inlet hose is not connected to the tap. • The START/PAUSE button has not been pressed. [. . . ]