User manual INDESIT K3C36G

[. . . ] The appliance must be installed by a qualified professional according to the instructions provided. Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. The legs* fit into the slots on the underside of the base of the cooker. Positioning !This unit may be installed and used only in permanently ventilated rooms according to the British Standards Codes Of Practice: B. S. [. . . ] Remove the hob grids and slide the burners off their seats. Unscrew the nozzles using a 7 mm socket spanner (see figure), and replace them with nozzles suited to the new type of gas (see Burner and nozzle specifications table). Replace all the components by following the above instructions in reverse. Adjusting the hob burners minimum setting: 1. Remove the knob and adjust the regulatory screw, which is positioned inside or next to the tap pin, until the flame is small but steady. If the appliance is connected to a liquid gas supply, the regulatory screw must be fastened as tightly as possible. GREEN & YELLOW BROWN 13 amp fuse BLUE CROSS-BAR CORD GRIP 3. While the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame is not extinguished. 4 The hob burners do not require primary air adjustment. After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one that corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres). Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to regulators for channelled gas. 5. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished. Adapting the grill Replacing the grill burner nozzle: 1. Before operating the product, remove all plastic film from the sides of the appliance. Never put objects directly on the bottom of the oven; this will avoid the enamel coating being damaged. Only use position 1 in the oven when cooking with the rotisserie spit. Lighting the oven To light the oven burner, bring a flame or gas lighter close to opening . (see figure) and press the OVEN control knob while turning it in an anticlockwise direction until it reaches the MAX position. If, after 15 seconds, the burner is still not alight, release the knob, open the oven door and wait for at least 1 minute before trying to light it again. F ELECTRONIC LIGHTING DEVICE * Only available in certain models. 8 The oven is fitted with a safety device and it is therefore necessary to hold the OVEN control knob down for approximately 6 seconds. If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight the oven. Adjusting the temperature To set the desired cooking temperature, turn the OVEN control knob in an anticlockwise direction. Temperatures are displayed on the control panel and may vary between MIN (140°C) and MAX (250°C). Once the set temperature has been reached, the oven will keep it constant by using its thermostat. Grill To light the grill, bring a flame or gas lighter close to the burner and press the OVEN control knob while turning it in a clockwise direction until it reaches the , position. The grill enables the surface of food to be browned evenly and is particularly suitable for roast dishes, schnitzel and sausages. [. . . ] The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. Exhausted appliances may be collected by the public waste collection service, taken to suitable collection areas in the area or, if permitted by current national legislation, they may be returned to the dealers as part of an exchange deal for a new equivalent product. All major manufacturers of household appliances participate in the creation and organisation of systems for the collection and disposal of old and disused appliances. Respecting and conserving the environment You can help to reduce the peak load of the electricity supply network companies by using the oven in the hours between late afternoon and the early hours of the morning. Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. 11 Care and maintenance 02/2009 - 195049686. 03 XEROX . ABRIANO G B Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven periodically. [. . . ]