User manual INDESIT K6C8PG

[. . . ] Always keep this owner's manual close to hand since you may need to refer to it in the future. 5 When you have removed the packing, check that the appliance is not damaged. If you have any doubts, do not use the appliance and contact your nearest Ariston Service Centre. Never leave the packing components (plastic bags, polystyrene foam, nails, etc. ) within the reach of children since they are a source of potential danger. [. . . ] During operation the back panel of the cooker could reach a temperature of 4 Fig. B Gas connection The cooker should be connected to the gas-supply by a corgi registered installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed "Adaptation to different gas types". On some models the gas supply can be connected on the left or on the right, as necessary; to change the connection, reverse the position of the hose holder with that of the cap and replace the gasket (supplied with the appliance). In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force. The gas supply must be connected to the left of the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts. Min. 420 mm. 420 mm. HOT PARTS Important: make sure the supply pressure conforms with the values shown in the table entitled "Caracteristics of the burners and nozzles". When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use. How to connect an alternative plug: The wires in this mains lead are coloured in accordance with the following code: BLUE "NEUTRAL" ("N") BROWN "LIVE" ("L") GREEN AND YELLOW "EARTH" ("E") GREEN & YELLOW BROWN 13 amp fuse BLUE CROSS-BAR CORD GRIP Disposing of the appliance When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above. Adapting the cooker to different types of gas In order to adapt the cooker to a different type of gas with respect to the gas for which it was produced (indicated on the label attached to the lid), follow these steps: a) replace the hose holder mounted on the appliance with that supplied in the bag of "cooker accessories". Tray for Catching Overflows Gas Burner Top Grate Control Panel Adjustable Feet or Legs Dripping Pan or Baking Sheet Electronic Lighting Device Oven Rack Selection knob Thermostat knob Control Knobs for Gas Burners on Hob The oven-operating pilot lamp Timer Knob Electronic Lighting for Hob Burners J A B E D K O G T S M L N F 8 The different functions and uses of the oven The various functions included in the cooker are selected by operating the control devices located on the cooker control panel. Control Knobs for the Gas Burners on the Hob (N) The position of the gas burner controlled by each one of the knobs is shown by a symbol of a solid ring:·. To light one of the burners, hold a lighted match or lighter near the burner. Press down and turn the corresponding knob in the counterclockwise direction to the maximum E setting. Each burner can be operated at its maximum, minimum or intermediate For any selection-knob setting different from idle, identified by the "0", the oven light turns on; the knob setting marked 8 permits turning on the oven light without any heating element being switched on. When the oven light is on, it means that the oven is in use, and it will remain on for the entire time the oven is being used. - Knob "L" setting: a - Knob "M" setting: anywhere between 50°C and Max The oven light turns on and the top and bottom heating elements (resistors) switch on. [. . . ] To install the protective glass for the oven door (code 076650), contact your nearest Merloni Eletrodomestici Service Centre indicated on the list provided with the appliance. the knob one full turn clockwise 4; then turn it back 5, to the desired time so that the number of minutes on the knob matches the reference mark on the panel. Attention Avoid the children touch the oven door because it is very hot during the cooking. Practical advice for burner use In order to get the maximum yield it is important to remember the following: · Use appropriate cookware for each burner (see table) so as to avoid flames overshooting the edges. · At boiling point turn the knob to minimum. · Always use cookware with flat bottoms. Burner Fast (R) Semi Fast (S) Auxiliary (A) ø Cookware diameter (cm) 24 - 26 16 - 20 10 - 14 10 Cooking advice The oven offers a wide range of alternatives which allow you to cook any type of food in the best possible way. [. . . ]